User manual SMEG FA40X5

[. . . ] Keep the instructions for future reference. On receipt, check to ensure that the appliance has not been damaged during transport. Transport damage should be reported 2 GB Get to know your refrigerator Control panel Lighting Bottle rack Nameplate Shelf with storage boxes Door shelf Glass shelf Sealing strip Door handle Crisper bins Kick plate Adjustable feet fig. 1 3 GB Installation and start-up Placement 600 600 For safety and operational reasons, the appliance must not be installed outdoors. The appliance should be placed on a level surface in a dry, well ventilated room (max. [. . . ] If it does not, carefully heat the strip all the way round using a hair dryer. Then ease the strip outwards slightly so that it forms a tight seal against the cabinet. Be careful not to heat the strip so much that it melts! 7 GB Electrical connection The appliance is intended for connection to alternating current. The required voltage (V) and frequency (Hz) are stated on the nameplate inside the appliance. Power must be connected via an independent wall socket outlet. Technical data This appliance complies with CE marking regulations, directives and standards. Council Directive 92/75/EEC on the energy labelling of household appliances as subsequently amended by 94/2/EC and 2003/66/EC. Directive 96/57/EC on energy efficiency requirements, and subsequent amendments. 8 GB Operation and function Control lamp 7 6 5 0 1 2 4 3 Lighting Thermostat button fig. 12 The thermostat button can be set from 1 (less cold) to 7 (more cold). A suitable setting must be found by trial and error. Check the temperature, then adjust the setting upwards or downwards as required. Usually, a temperature of 5°C is recommended for items stored in a refrigerator. To check the temperature, place a thermometer in a glass of water positioned in the centre of the cabinet for 12 hours. The average temperature is usually found in the centre of the cabinet. The chiller section corresponds to an old-fashioned larder. The temperature fluctuates between +8ºC and +12ºC. Temperature control of chiller section: The refrigerator and chiller sections are separated by a temperature plate, positioned above the crisper bins. 9 GB Layout and fittings Glass shelves The shelves are made of tempered glass and can be repositioned within the cabinet. To move the shelves, the door must be opened 90°. To remove a shelf, pull it forwards and lower it. The shelf can then be removed and placed in the desired position. From the top and downwards, the shelves are suitable for storing bakery products, ready-made meals, dairy products, meat products and sliced meat. Glass shelf with slide damper The slide damper above the crisper bins allows the temperature and humidity in the bins to be regulated. - Opening the damper reduces the temperature and humidity. - Closing the damper increases the temperature and humidity. Storage boxes The storage boxes can either be placed in the door or on the glass shelves. The tightfitting lids prevent items stored in the boxes from drying out. [. . . ] The appliance is resting against other kitchen elements. Bins, containers or shelves are not positioned correctly or are jammed. Containers or bottles inside the cabinet are rattling against one another. Many items have been placed in the refrigerator section at the same time. [. . . ]