User manual SMEG FV15G1

[. . . ] Note: this operation does not disconnect the appliance from the power supply. Key Lock The key lock can be activated/deactivated by pressing and holding the "Key Lock" button for 3 seconds, until you hear a confirmation tone (the icon lights up). If you press any button while the key lock is active, you will hear a sound and the "Key Lock" icon will start to flash. GB Fan (where provided) The fan is factory set to ACTIVE. The fan can be deactivated by pressing the button on the base (as shown in the figure). [. . . ] The characteristics, technical data and images may vary according to the model. Freezer compartment temperature alarm Press the Stop Alarm button to deactivate the acoustic signal. When the optimal temperature conditions have been The temperature alarm indicates that the temperature of the compartment is not at its optimum reached, the red light switches off automatically. If the temperature alarm persists, contact the Authorised Service level. This may happen: when it is first used, after defrosting and/or cleaning, if large amounts of Centre. food are placed inside the freezer or when the freezer door has not been shut properly. 04/12 FIRST USE Connect the appliance to the mains power supply. A beep may be emitted by some models, to indicate that the temperature alarm has intervened: press and hold the button to switch off acoustic alarms. As applicable, insert the anti-bacterial/anti-odour filter into the fan as indicated on the filter package. Note: after switching on, the refrigerator needs approximately 4/5 hours to reach the correct temperature for storing a normal fridge load of food. APPLIANCE MAINTENANCE AND CLEANING Clean the appliance regularly using a cloth and a solution of lukewarm water and neutral detergent specifically formulated for refrigerator interiors. Clean inside the defrost water drain outlet on the rear wall of the refrigerator (near the fruit and vegetable crisper drawer) regularly, using the tool supplied with the appliance so as to ensure defrost water is removed correctly (see figure). Before all cleaning or maintenance procedures, unplug the appliance from the mains or disconnect the electricity supply. CHANGING THE BULB OR LED (depending on the model) Always unplug the refrigerator before replacing any light bulbs, then follow the relevant instructions in accordance with the type of lighting fitted in your appliance. Only use bulbs of the same type, which can be requested from the After-Sales Service and authorised dealers. To save energy and prolong the life of the appliance, make sure hot foods are never placed inside it. Note: the ambient temperature, door opening frequency and position of the appliance can affect the temperatures inside the two compartments. Set the temperature based on these factors. Making ice cubes Fill the ice cube tray (where provided) 2/3 full and place it in the freezer compartment. Never use sharp or pointed objects to remove the ice. Removing drawers (depending on model) Pull the drawers all the way out, lift them up a little and remove. To create more space, the freezer compartment can also be used as follows: A) If the freezer compartment base resembles figure A, remove the upper drawers and/or lids. The lower drawer should be left in position. Make sure that, once the food has been placed on the racks/shelves, the door closes properly. B) If the freezer compartment base resembles figure B, remove all drawers or lids. Make sure that, once the food has been placed on the racks/shelves, the door closes properly. [. . . ] In this case, temporarily deactivate the function. When placing small containers and food products on the top shelf of the "zero degrees" compartment, make sure they do not accidentally fall between the drawer and the back of the refrigerator compartment . Removing the "Zero Degrees" box: The "Zero Degrees" box can be removed to create more space inside the refrigerator. In this case proceed as follows: - to facilitate removal, we recommend emptying (and if necessary, removing) the two lower door trays - switch off the box - pull out the drawer and the white plastic shelf underneath the box. 14 Note: the upper shelf and the side supports cannot be removed. To restore "Zero Degrees" box operation, make sure you replace the white plastic shelf underneath the box before inserting the drawer and reactivating the function. [. . . ]