User manual SMEG GW1060-3

[. . . ] If instructions are not adhered to, you may lose your right to service at no charge during the warranty period. Please keep this manual in a safe place and pass it on to later users if applicable. · Do not connect your appliance to the power supply until all packing and transit protectors have been removed. · Leave to stand upright for at least 4 hours before switching on to allow the system to settle if transported horizontally. [. . . ] Each time the quick-freeze function is activated, "-27" blinks on the display for 5 seconds only. Then the actual freezer temperature will be shown. Quick freeze function lasts for maximum 3 hours. When the quick-freeze function is completed, icon will light off automatically and the previous freezer set temperature will be recalled. Quick freeze function terminates automatically in 3 hours. To deactivate quick-freeze function manually, it is enough to press quick freeze button once more or freezer set button. The electronic control system incorporates a safety protection so that if the quick freeze button is pressed more than once in a short time, then the compressor will not run immediately. Actual Fridge Temperature The average temperature of the packages inside the fridge compartment is shown here. Accordingly, this temperature is not sensitive to instantaneous changes. en f. Actual Freezer Temperature The average temperature of the packages inside the freezer compartment is shown here. Accordingly, this temperature is not sensitive to instantaneous changes. If you find the freezer door difficult to open just after you have closed it, don't worry. This is due to the pressure difference which will equalize and allow the door to open normally after a few minutes. You will hear a vacuum sound just after closing the door. Do not close air flow channels while loading. Defrosting of the appliance The appliance is a frost free refrigerator. So there will not be any frost accumulation inside the food storage area. However there will be an automatic defrost at the evaporation area of the appliance when it is required. The water is collected into a reservoir at the back of the appliance and evaporates automatically through the compressor heat. Ensure that the reservoir is fixed properly above the compressor. 7 en en Clean with water only, and wipe totally dry. Replacing the interior light bulb (Fig. 6-7) Should the light fail to work, proceed as follows. Switch off the circuit breaker or unplug the power cable. Then ensure the bulb is screwed securely in the bulb holder. [. . . ] There may be some oscillations on the actual fridge temperature shown on the display in the following conditions: a) The fridge door is Opened / Closed frequently b) Loading warm packages inside the fridge. c) Leaving the fridge door open for a long period of time What, if. . . 1- The appliance will not work, even though it is switched on. · Check if the power cable is properly connected!· Check if the mains supply is in order, or if a fcircuit breaker has been tripped! [. . . ]