User manual SMEG GW4060-1

[. . . ] · Any repairs and work on the appliance should only be carried out by the customer service department, as unauthorised work could prove highly dangerous for the user. The same applies to changing the mains power cable. · Do not allow naked flames or ignition sources to enter the appliance. When transporting and cleaning the appliance ensure that the refrigerant circuit is not damaged. [. . . ] The correct climate rating for your appliance is indicated on the type plate. Ambient temperature +10°C to +38°C Pull-out shelf Type plate Adjustable-height feet 6 Setting up · Avoid positioning the appliance in direct sunlight or near cookers, radiators and similar sources of heat. · The floor on which the appliance stands should be horizontal and level. To compensate for any unevenness, adjust the height of the feet with the open-ended spanner supplied. · Standard EN 378 specifies that the room in which you install your appliance must have a volume of 1 m3 per 8 g of R 600a refrigerant used in the appliance, so as to avoid the formation of inflammable gas/air mixtures in the room where the appliance is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant used in your appliance is indicated on the type plate on the inside of the appliance. Installation and fitting GB · Connect the appliance to the mains. · Slide the appliance into the recess. · Secure the appliance in the recess using 4 x 14 screws. Connecting to the mains Power supply (AC) and voltage at the operating point must comply with the details on the type plate, which is located inside the appliance on the left-hand side. The socket must be fused with a 10 A fuse or higher, it must be away from the rear of the appliance and must be easily accessible. Connect the appliance with a properly earthed fused plug and socket only. The wires in the mains lead are coloured in accordance with the following code: green/yellow = earth, blue = neutral, brown = live. Corks are prevented from drying out due to an increased level of humidity. 8 Interior light A lightbar is integrated into the upper and lower compartments. The interior light can be switched on and off using button . When cover is removed, do not look directly at light through optical instruments. The lighting may only be replaced by the customer service technician or by competent skilled personnel!Furthermore, the brightness of the lighting can be adjusted. Cleaning GB Before cleaning always switch off the appliance. Pull out the mains plug or remove/unscrew the fuse. Do not use steam cleaners because of the risk of injury and damage. · Press and hold button and at the same time press the temperature setting buttons to increase or decrease the brightness. · Press the LIGHT button . · Use a glass cleaner to clean the glass surfaces. · Only clean the door surfaces with a clean and soft cloth. If necessary, moisten the cloth (water + detergent). · Clean the inside and equipment with lukewarm water and a little detergent, with the exception of the wooden trims on the grid shelves. · Ensure that no cleaning water penetrates into the electrical components. [. . . ] Loud running noise: ­ Is the appliance set up firmly on the floor?­ Does the appliance cause nearby items of furniture or objects to vibrate?Please note that noises caused by the refrigerant circuit cannot be avoided. The temperature is not low enough: ­ Is the temperature setting correct (see "Setting the temperature")? [. . . ]