User manual SMEG HG736

[. . . ] THE ENVIRONMENT - DISPOSAL INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . USER RECOMMENDATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SUGGESTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] For filling the water tank, read paragraph "11. 1 Filling the tank". In normal operating conditions, the tank will ensure correct humidification for 25-30 days. This value is approximate and will depend on the climatic conditions and program selected. 14 Control panel 8. 4 Internal temperature/time display During normal operation, this displays the Home Garden's internal temperature. When first switched on, after a power shutdown or when the key is pressed, the display shows the time for setting. For instructions for setting the time, see "9. 6 Clock display/setting key" The Home Garden does not have a cooling function. It follows that the internal temperature will never be lower than the external temperature. 8. 5 Standby symbol When this is the only symbol lit up on the control panel, the appliance is in standby. 8. 6 Internal air humidity percentage/minutes display During normal operation, this displays the Home Garden's internal relative humidity (in %). When first switched on, after a power shutdown or when the key is pressed, the display shows the time for setting. For instructions for setting the time, see "9. 6 Clock display/setting key". The Home Garden does not have a dehumidifying function. It follows that the internal humidity will never be lower than the external humidity. 8. 7 Key lock/unlock symbol When the remote control has not been used for ten minutes consecutively, the Home Garden locks its current setting and commands are not accepted from the remote control. This is a precaution against misuse, accidental or in play, by children, who may attempt to change the settings and thus affect the growth of the plants. For instructions for deactivating the lock, see "9. 2 Standby key". 8. 8 Internal light ON symbol This symbol lights up whenever the key of the remote control is pressed, and stays on for around a minute during day time, and an hour at night. It can be switched off manually at any time by pressing the key when it is on. For instructions for the internal lighting function, see "9. 5 Internal light key". 8. 9 Cuttings function on symbol This symbol indicates that the "Cuttings" function is activated. If it is flashing, this means that the climatic conditions do not allow for activating the function. For instructions for the "Cuttings" function, see "9. 3 Cuttings function on key". 8. 10 Remote control sensor This sensor receives the signals emitted by the remote control whenever its keys are pressed and sends them to the control circuitry, which activates the corresponding components. Ensure that it is never blocked by any obstacles: they will block the signals from the remote control. 15 Remote control 9. THE REMOTE CONTROL RED LED STANDBY KEY "CUTTINGS" KEY HUMIDIFIER KEY INTERNAL LIGHT KEY CLOCK DISPLAY/SETTING KEY VALUE DECREASE KEY VALUE INCREASE KEY (Fig. 9) 9. 1 Red led This led switches on whenever any key is pressed to confirm that the signal has been sent to the control panel. 9. 2 Standby key This key activates the appliance's circuitry when it is in standby. When it is reconnected to the power supply, or after a lengthy power shutdown, the Home Garden will start up with the settings it had when it was switched off. In particular, when first switched on, the Home Garden will be in standby, as shown by the display described in point , page 15. To activate automatic operation, simply point the remote control at the appliance and press the key. [. . . ] The tank water level can be seen through the front window, under the control panel. When the level falls below a certain value, the symbol on the control panel will start flashing. When this symbol is flashing, the humidifier is not able to generate vapour and the tank must be filled as follows. WHEN THE SYMBOL STARTS FLASHING, SOME AMOUNT OF WATER IS STILL LEFT IN THE TANK, BUT IT CANNOT BE USED. [. . . ]