User manual SMEG IC5090

[. . . ] Some other models they have only one indicator (see description paragraph). Connection of electric heating elements Heating elements are controlled by energy regulators with 12 positions or by commutators with 6 positions that permit to obtain a big range of different temperatures. In Scheme 1, by way of information, we give instructions to obtain different cooking levels. To connect the heating elements is necessary to turn clockwise or anticlockwise the relative knob. [. . . ] Be aware that overheated fats and oils may become inflamed. Cooking zones after using remain warm; don't leave objects, don't lean your hands so to avoid burns, till the indicator light is off. If the glass cracks, please, disconnect the appliance. Don't use plastic pots or alluminium sheets. Don't use hob as a supplementary surface. - - FIG. 2 21 CLEANING Before any cleaning operation, disconnect the appliance from the electric circuit. 2) ELECTRIC HOB If you want to preserve the surface clean and bright, we recommend you to use a silicone conditioner. The use of this conditioners, prior to jam-making, helps to protect the surface of the hob. It is very important to clean the surface soon after every use, when the glass is still tepid. Do not use metallic sponges, powder abrasives or corrosive sprays. Depending on the dirty level we recommend: - Slights stains: it is enought the use of a moist clean rag. - Burnt or soiling may be removed with a special razor scraper (fig. - Take the protective paper strip of the seal off, place the hotplate in the opening made in the table top, and lock it with the special screws "F" (fig. WARNINGS: Be aware that the glue that join the laminated plastic to the furniture, has to resist to temperature not below 150° C, to avoid the unstuck of the panelling. The installer should bear in mind that the mixed appliance is the Y type. The rear wall, adjacent and surrounding surfaces must therefore be able to withstand an overtemperature of 65 K. 4 HEATING ELEMENTS 1 or 2 HEATING ELEMENTS FIG. 11 24 INSTALLATION 5) ELECTRICAL CONNECTION The electrical connection has to be done in accordance with all electrical and installation requirements of the regulation. Before proceeding with the connection, please, verify that: - The power of the electrical system and the power of the outlets is adequate to the maximum power of the appliance (see the identification label in the lower part of the body). - The outelets and all the electrical system has an efficient connection to the "earth" according with the Regulation. We disclaim all responsabilities for not observing such points. - If the appliance is not equipped with an input cable, connect to the clump with an adequate section cable (see scheme paragraph 6) keeping the "earth" conductor longer than "live" ones, following the scheme of fig. When the connection to the input system has been done through a outlet: - Apply to the input cable "C", if unprovided, a normalized plug adequate to the load indicated in the identification label. Connect the cables according to the scheme of fig. 12 and fig. [. . . ] d) Connect the phase cable into the clamp and the "earth" cable in the relative clamp. e) Hold up the input cable with the pertinent stopcable. f) Replace the panel in its seat and hold up with the pertinent screws "V" (see fig. 15 26 MAINTENANCE Before doing any action, disconnect the appliance from the input power. 7) COMPONENTS SUBSTITUTION To replace the components lodged in the internal part, is necessary to take the appliance up from the furniture, overturn it, loosen the screws and take away the bottom. [. . . ]