User manual SMEG KQ45X-1

[. . . ] gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0, 04 mbar to prevent fumes being drawn back into the room by the cooker hood. • In the event of damage to the power cable, it must be replaced by the manufacturer or by the technical service department, in order to prevent any risks. INSTALLATION USE • The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. [. . . ] • Fix the pipe with an adequate quantity of pipe clamps. This material is not supplied together with the hood. • Remove the charcoal filter if present. • Fix the metal cover 10 to the upper air outlet hole of the hood by using the screws supplied. UPPER AIR OUTLET • In case the connection is made by using a ø 120 mm pipe insert the reduction flange 9 on the hood body outlet. • Use a pair of tongs when removing the central part of the metal cover 10. Fix the cover to the air outlet hole of the hood by using the screws supplied. • Fix the pipe with an adequate quantity of pipe clamps. This material is not supplied together with the hood. • Remove the charcoal filter if present. ø 150 9 ø 120 10 10 EN 1 15 AIR OUTLET IN A RECYCLING HOOD VERSION • In case the components requested for the recycling functioning have been removed earlier these have to be positioned again. • Put the plastic tube onto the flange 7. • Place the air outlet grid 8 on the air outlet. Make sure that the position of the grid is correct. • Make sure that charcoal filters have been placed inside the hood. 8 7 ELECTRICAL CONNECTION • Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. • Remove the grease filters (see paragraph Maintenance) being sure that the connector of the feeding cable is correctly inserted in the socket placed on the side of the fan. EN 1 16 USE L1 L2 L3 L4 L T1 T2 Control panel T3 T4 But ton L Function Turns the lighting system on and off. Led - Press and hold for approx. 2 seconds to turn the lighting system on and off at reduced intensity. T1 Turn the suction motor on and off at speed one. Press and hold the button for approximately 2 seconds, After 100 working hours all the with all the loads turned off (Motor and Lights), to reset LEDs (L1-L2-L3-L4) will light up and remain lit to indicate saturation the Filters and turn off the Leds that are lit. After 200 working hours all the LEDs (L1-L2-L3-L4) will light up and start to flash to indicate saturation of the activated charcoal filters. T2 Turn the suction motor on at speed two. [. . . ] Changing the Filter • Pull the Comfort Panels to open them. • Remove the saturated Activated Charcoal Filters, as indicated (A). • Fit the new Filters, as indicated (B). • Replace the Metal grease filters. [. . . ]