User manual SMEG KSEC6

[. . . ] 1. 6 - When installed, the hood must be positioned at least 65cm above the hotplate. 1. 7 - Never do flambé cooking under this cooker hood. 1. 8 - Never leave frying pans unattended during use as overheated fat and oil may catch fire. [. . . ] b - Internal recirculation mode To check that the hood is set up for recycling, open the grille panel and make sure that the conversion lever or the change-over knob on the centrifugal unit is in the RECYCLING position. To fit the charcoal filter, support the filter with one hand and turn the thumb screw through the centre of the charcoal filter. If the filter is of the interlocking type, turn the filter clockwise. The hood can remain connected to the outside. 2. 5 - Electrical connection and working test 1 - The safety measures 1. 2, 1. 3, 1. 4 and 1. 5 of paragraph 1 are to be strictly observed. 2 - Once the electrical connection has been completed, check that the worktop illumination, motor and speeds work properly. EN 1 11 USE - MAINTENANCE 3 - OPERATION 3. 1- Controls are located on the right hand side of the front to operate worktop illumination and select the most suitable working speed for your cooking. To increase the area of extraction, the glass visor should be pulled open. The top speed should be used when frying or cooking foods with strong odours, while a lower speed can be used for normal cooking. To obtain the best performance from your hood, turn it on before you start cooking and leave it running for a few minutes after your cooking is over to clear the air. 3. 2- Pay attention to safety regulations 1. 7 and 1. 8. 4 - MAINTENANCE AND CLEANING Regular maintenance and cleaning will ensure good performance and reliability, while extending the working-life of the hood. Special attention should be reserved to the grease filter and to the charcoal filter (recycling mode). 4. 1 - Grease filter This retains the solid grease particles and can be supplied in different types. lt is fitted onto the reverse side of the metal grille panel. Maintenance of the grease filter varies according to the used type. a-Whatever type of filters used, the filter is easily removed from the grille by pushing the metal wire clips to one side and removing. It should not be washed and should be replaced every two months. If the filter is provided with a saturation indicator, replace when: b. 1-The violet colour of the dots, which are visible through the metal grille, is spread over the whole surface of the filter. b. 2-The red colour of the stripes, which is not visible through the metal grille when the filter is clean, becomes visible from the outside of the metal grille. [. . . ] Il doit plutôt être remis au point de ramassage concerné, se chargeant du recyclage du matériel électrique et électronique. En vous assurant que ce produit est éliminé correctement, vous favorisez la prévention des conséquences négatives pour l'environnement et la santé humaine qui, sinon, seraient le résultat d'un traitement inapproprié des déchets de ce produit. Pour obtenir plus de détails sur le recyclage de ce produit, veuillez prendre contact avec le bureau municipal de votre région, votre service d'élimination des déchets ménagers ou le magasin où vous avez acheté le produit. [. . . ]