User manual SMEG KSEIL90X1

[. . . ] Hood featuring control panel with keypad The grease filters must be washed at least once a month. Hood with electronic control panel The metal grease filters must be washed at least once a month and anyhow whenever the metal grease filter saturation led (Speed 2 LED) indicates the saturation of the filter. [. . . ] Put the metal filter back into place. Carbon filter ("recirculation mode only", see next pages) The carbon filter cannot be washed nor regenerated. Hood featuring control panel with keypad The carbon filter should be replaced every 6 months under normal use. Hood with electronic control panel The carbon filter should be replaced every 6 months under normal use and anyhow whenever the carbon filter saturation led indicates the saturation of the filter. This LED indicates carbon filter needs to be replaced. This led flashes to warn you that the carbon filter must be replaced. This must be done after approximately 160 hours of use. Read the instructions reported below for replacing the carbon filter. Once you have replaced the carbon filter, press button A and button B together for about two seconds (see page 11) until you hear the acoustic signal (beep). The carbon filter saturation led C will now stop flashing. N. B. : the carbon filter saturation led will also flash even if the hood is used in the exhausting version (i. e. To stop the led flashing, press the two buttons A and B as described above. Disconnect the hood from the electricity. Fit the carbon filter and fix it to the body of 12 Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Wipe brushed stainless steel in the same direction as the brushing to avoid scratching. Attention Failure to observe the instructions for cleaning the appliance and changing and cleaning the filters may cause fires. [. . . ] If the hood is supplied with carbon filter, then it must be removed. Recirculation mode The air is filtered through a carbon filter and recirculated into the room through the grid on the higher part of the chimney. If the hood is not supplied with carbon filter, then it must be ordered and mounted. Installation These minimum distances between hobs and grease filter must be observed: Minimum 600 mm - electric hobs Minimum 700 mm - gas or mixed hobs Electric connection Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood It is advisable to call a qualified technician to make the electrical connection. Appliance fitted with plug. [. . . ]