User manual SMEG KSEIV97X

[. . . ] USE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has ben designed. · Never leave high naked flames under the hood when it is in operation. · Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] · Push fit connection 15 onto the hood body extension piece 14. · Insert the connection extension pieces laterally 14. 1 in connection 15. 15 14. 1 14 GB 17 Flue assembly - Mounting the hood body · Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. · Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Recirculation version · Make sure that the outlet of the extension pieces 14. 1 is horizontally and vertically aligned with the chimney outlets. · If this is not the case, remove the lower chimney section and adjust the position by either reversing the connection extension pieces 14. 1 or by cutting the hood body extension 14 along one of the thinner section channels denoting the pre-fixed lengths, then reassemble as described previously. · Fit the directional grids 8a - 8b in their housings making sure that the directional symbols are towards the top. Also make sure that they are correctly inserted in the connection extension pieces 14. 1. Before fixing the hood body to the frame: · Remove the grease filters from the hood body. · Remove any activated charcoal filters. · From below, use the 4 screws 12f (M6 x 10) provided to fix the hood body to the frame. ELECTRICAL CONNECTION · Connect the hood to the mains through a twopole switch having a contact gap of at least 3 mm. · Connect the control connector Cmd. · Connect the lights connector Lux. · Place the connector in the junction box 24 and close it using the 2 screws 12e (2, 9 x 9, 5) provided. · Fix the junction box to the hood body using the 2 screws 12c (2, 9 x 6, 5) provided. · For the recirculation version, fit the activated carbon odour filter. · Replace the grease filters. 12c 8b 8a 12c 12f 24 12e Lux 12c Cmd GB 18 USE Control panel S1 S2 R L M V1 V2 V3 L Light Switches the lighting system on and off. It flashes once after 100 working hours of the hood to indicate that the grease filters need washing. It flashes twice after 200 working hours to indicate that the grease filters need washing and that the anti-odour charcoal filters, if any, need changing. Switches the extractor motor on and off at low speed. Used to provide a contin-uos and silent air change in the presence of light cooking vapours. When the Hood is in ELC (Electronic Comfort) mode, the button will not only turn the Ducting motor on, but will also disable this function. S 1 Led S 2 Led M Motor V1 Speed Reduces the operating speed. [. . . ] 89/336 relativa alla compatibilità elettromagnetica e C. E. E. This appliance conforms to European Low Voltage Directive 73/23/CEE governing electrical safety, European Directive 89/ 336/CEE on Electromagnetic Compatibility and Directive 93/68/CEE regarding CE Marking. Cet appareil est conforme à la norme européenne en matière de basse tension C. E. E. 73/23 de sécurité électrique ainsi qu'aux normes européennes : C. E. E. [. . . ]