User manual SMEG KSET65

[. . . ] The installion (or removal) steps are identical for hoods with either 1 or 2 motors: a. Request a charcoal filter from the retailer, specifying the model and type of hood (1 filter for a hood with one motor and 2 filters for a hood with 2 motors). Some charcoal filters come covered with a plastic film to protect their filtering properties. [. . . ] To mount the hood proceed as follows: a. Drill holes in the bottom of the cabinet so that they correspond with the holes (F) in the hood used to fasten it to the cabinet. Use the drilling template if it has been provided (the edge with the arrow should correspond with the back edge of the cabinet - Fig. Drill a hole on the back and in the top of the cabinet for the ventilation duct (a good rule of thumb is to make the diameter of the hole 15 mm larger than that of the duct used). Insert the C screws supplied with the hood into the F holes and tighten the hood to the cabinet (Fig. 7). Electric connection Before completing any connections, make sure the house voltage corresponds with the voltage indicated on the data plate affixed to the inside of the hood. It is advisable to call a qualified technician to make the electrical connection. Hood Fitted with Plug Insert the plug into a socket which complies with current regulations. If you intend to connect the hood directly to the mains, remove the plug and fit an approved bipolar switch with a minimum contact opening of no less than 3mm. If the plug is not accessible once it has been inserted in the socket, it will, however, be necessary to fit an approved bipolar switch with a minimum contact opening of no less than 3mm. Appliance without Plug Fit an approved plug or an approved bipolar switch with a minimum contact opening of 3mm. The manufacturers will not be held liable for any problems caused by the user's failure to observer the above instructions. Assembly using side brackets (if supplied) The hood can also be mounted by means of two brackets supplied with the hood. Drill two holes Ø 2 mm on the two sides of the cupboard from the inside using the template Q supplied. Fix the two brackets T to the upper side of the hood using screws V 4, 2 x 35 (the position of the brackets can be adjusted in width according to the thickness of the cupboard panels). Fix the hood, through the brackets already mounted, on the inside of the cupboard using screws Z 3, 5 x 13 (two each side). Adjusting the Pull-Out Drawer The hood can be installed beneath cabinets with varying depths. Adjustments for opening and closing the drawer can be made based on your specific needs. [. . . ] b) Remove the L fasteners for the grease filter and remove it (Fig. If special metal filters have been installed, press on the plastic springs (S) to unhook them (Fig. c) When washing or replacing the grease filter, wash the grate as well with warm soapy water. [. . . ]