User manual SMEG KSET900

[. . . ] Push the A knobs inwards toward each other (in the "Open" direction as indicated on the plastic knob itself). To remove the grates completely, use the B spring fasteners, which act as pins to hold the grate in place (Fig. 3). Model with Self-supporting Metal Filters Removing the Grease Filters - Fig. [. . . ] -- The filtered air is returned from atop the cabinet through a duct that passes through the cabinet itself. The diameter of the duct must be the same as that of flange Electrical connection The electrical tension must correspond to the tension noted on the label placed inside the cooker hood. Connect the electrical plug, where provided, to the an easily accessible 7 GB outlet in conformity with local standards in force. Where an electrical plug is not provided (for direct connection to electrical network) place a standards approved bipolar switch with an aperture distance of not less than 3mm (accessible) from the contacts. warm soapy water, or, if possible, in the dishwasher (60°C). Removing the Grease Filters (for models wtih grease filter support grates) To remove the dirty grease filter, proceed as follows: a. Remove the pull-out drawer completely and open the ventilation grates that support the grease filters. Remove the Q fasteners for the grease filter and remove it (Fig. If special metal filters have been installed, press on the plastic springs R to unhook them (Fig. When washing or replacing the grease filter, wash the grate as well with warm soapy water. Remount the new filter or the old one after it has dried thoroughly. Mounting the Hood The diameter of the ventilation duct must be the same as the that of the flange mounted on the ventilation hole on the hood. To mount the hood proceed as follows: -- Position the drilling template inside the left cupboard on the right hand side with the arrow point towards the back on the cupboard (Fig. 8) -- Drill the holes marked on the template (Fig. 8) -- Repeat the procedure for the right hand cupboard -- If the sides of the cupboards are 18 mm thick, insert 4 spacers M on the sides of the hood (Fig. 9) -- Fix the hood to the cupboard using four screws N (Fig. 9). Charcoal Filter The charcoal filter serves to eliminate odours that form during the cooking process. Under normal use conditions, the filter should be replaced every 4 months. [. . . ] Attention Failure to observe the instructions for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Maintenance Caution!Before performing any maintenance, disconnect the hood from the electrical supply. Grease Filter The grease filter serves to trap grease particles by suspending them. [. . . ]