User manual SMEG KSET900X

[. . . ] This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the appliance. This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Never use the hood without effectively mounted grating! [. . . ] Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Mounting Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. Do not tile, grout or silicone this appliance to the wall. This hood is designed for fitting in a cabinet or on some other support. The diameter of the ventilation duct must be the same as the that of the flange mounted on the ventilation hole on the hood. To mount the hood proceed as follows: Position the drilling template inside the left cupboard on the right hand side with the arrow point towards the back on the cupboard. Repeat the procedure for the right hand cupboard If the sides of the cupboards are 18 mm thick, insert 4 spacers Z on the sides of the hood. Fix the hood to the cupboard using four screws N. 8 Model with Self-supporting Metal Filters Removing the Grease Filters - Fig. Press the side handles C (some models are supplied with handles Z - Fig. 2. 3) towards the opposite side and remove the filters. Remove the pull-out drawer completely and mount the grease filter so that it covers the drawer. Close the drawer and install the remaining grease filter. According to model in possession: Lamp D with hook locks type A - Fig. 2. 2 Move the bracket hook locks towards each other (in direction “Open” as printed on the plastic part of the lock). 1. 2 Move the hook locks as indicated by the arrows and completely remove the lamp from the housing (Fig. 1. 3). Operation The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Maintenance Additional instructions for the montage Box adjustement The hood can be installed in cabinets with different depths, the front of the box must always be in line with the cabinet. For alignment adjust the back stops of the box. [. . . ] 40 Watt (E 14) bulbs, or neon-lamp 14 Watt max. , or PL lamp 11 Watt (one PL lamp appliance) or PL 9 Watt (two PL lamp appliance). Close the light cover support or the back grease filter support grate. If the lights do not work, make sure that the lamps are fitted properly into their housings before you call for technical assistance. Charcoal filter (filter version only) It absorbs unpleasant odours caused by cooking. The saturation of the activated charcoal occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. [. . . ]