User manual SMEG KT90XU

[. . . ] CAUTION – For General Ventilating Use Only. Do Not Use For To Exhaust Hazardous Or Explosive Materials And Vapors. Do not cook or fry in a way that could result in flames being sucked into the hood and causing a fire. The hood surface can be cleaned with a damp cloth and a non-bleach liquid detergent. [. . . ] The L1 holes for these supports are on the back of the hood (fig. 4) c) Remove the anti-grease filters, put the hood on the wall and mark the position of the holes for the supports/hooks. d) Drill the two previously marked holes after removing the hood from the wall. e) Fix the two supports/hooks to the wall. f) Mark the L2 holes on the wall to fix the hood safely. 4) Drill and put the anchors in the holes. g) Hang the hood on to the supports/hooks (fig. 5) and level by means of the adjusting screw (fig. 3). l) Fix the hood safe by tightening both wall anchors. Ducted mode or Recirculation mode installation: Ducted mode: In the ducted mode, connect the motor outlet to the fumes outlet duct not less than 120mm diameter. Warning: if the hood is equipped with an active carbon filter, it must be removed (see page7) EN 4 Recirculation mode: Leave the motor intake free. Install the active carbon filters as shown in page 7. Warning: if the hood is not supplied with an active carbon filter, it is necessary to buy it separately and assemble it before using the hood. m) Chimney assembly: Adjust the two telescopic chimneys to the required length (fig. Block the chimneys by tightening the two H screws . Place the chimneys group on the top side of the hood carefully. Put the chimney bracket K on the B chimney (fig. Mark the holes on the wall for fixing the chimney bracket to the wall. Remove the chimney set, drill and fix the support racket to the wall by means of wall anchors. Put the chimney group back in place and fix it to the hood with the Z screws and to the chimney bracket with the L screws as shown in figure 6. ELECTRICAL CONNECTION It is recommended that all electrical connection operations are performed by a qualified technician. The appliance is supplied WITHOUT A PLUG. It is therefore necessary to fix a plug to the wire. [. . . ] a) Incandescent lamps: E14 – 40W 230V lamps. To replace them, remove the transparent fixture from the control panel, unscrew the lamp and screw in the new one. To replace the lamp, use a screwdriver to remove the glass-supporting ring. Then remove the old lamp and insert the new one. [. . . ]