User manual SMEG KTL6

[. . . ] CONTENTS BEFORE USING THE WASHING MACHINE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE BEFORE THE FIRST WASH CYCLE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES CLEANING THE FILTER/ DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE TRANSPORT AND HANDLING INSTALLATION ELECTRICAL CONNECTION BEFORE USING THE WASHING MACHINE 1. Remove the packaging and check a. b. Remove the top protection and the protective corners. Remove the bottom protection by tilting and turning the washing machine on one rear bottom corner. Make sure that the black plastic part of the bottom protection (if available on the model) remains in the packing and not in the machine bottom. [. . . ] Detergent dispenser · Detergent dispenser is not properly installed, or detergent dispenser is contains residues from blocked (see "Care and Maintenance"). detergent/additives at end · Filter in the water inlet hose is blocked (see "Care and Maintenance"). of wash Appliance vibrates during · Washing machine is not level; the feet are not properly adjusted (see spin cycle "Installation"). · The transport bracket has not been removed; before using the washing machine, the transport bracket must be removed. Final spin results are poor The appliance has an imbalance detection and correction system. If individual heavy items are loaded (e. g. bathrobes), this system may reduce the spin speed automatically or even interrupt the spin completely in order to protect the washing machine. · Heavy items prevented spinning; add smaller articles of laundry and repeat spin cycle. · Excessive foam formation prevented spinning; select and start "Rinse & Spin" programme. Avoid excessive detergent dosing (see "Detergents and Additives"). · "Variable spin" button (if available on your model) has been set to a low spin speed, or "No spin" option (if available on your model) has been activated. Programme time is some longer/shorter than initially displayed (only for appliances having a display which indicates the remaining programme time) Normal capacity of the appliance to adapt to factors that can have an effect on the wash programme time, e. g. : excess of foam formation, load imbalance due to heavy items of laundry, prolonged heating time resulting from reduced inlet water temperature. Due to such influences, the programme time is recalculated and updated if necessary. On certain displays (depending on the model), an animation appears during such update periods. GB 12 Description of red indications Red indication lamp lights up Indication on display (if fitted on your machine) Description Causes Solutions Appliance has no or insufficient water supply. The "Start/Pause" light flashes. Check whether: · Water tap is fully open and water supply pressure is sufficient. · Kinks are present in water inlet hose. · Mesh filter of water supply hose is blocked (see "Care and Maintenance". · Safety valve inspection window of your water supply hose is red (provided your appliance has a water supply hose as shown on picture "A" - see previous chapter "Care and Maintenance"); replace the hose by a new one available through our After-Sales Service or your specialist dealer. After problem has been removed, restart programme by pressing "Start/Pause". If the fault occurs again, contact our After-Sales Service (see next chapter). [. . . ] The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. · Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. "DOOR OPEN" INDICATION Before starting and after end of a programme, the lamp lights to show the the lid can be opened. [. . . ]