User manual SMEG LC94.1

[. . . ] Push the A knobs inwards toward each other (in the "Open" direction as indicated on the plastic knob itself). To remove the grates completely, use the B spring fasteners, which act as pins to hold the grate in place (Fig. Press the side handles C (some models are supplied with handles Z - Fig. According to model in possession: Lamp D with hook locks type A - Fig. [. . . ] According to model in possession: Lamp D with hook locks type A - Fig. 2 Move the bracket hook locks towards each other (in direction "Open" as printed on the plastic part of the lock). 2 Move the hook locks as indicated by the arrows and completely remove the lamp from the housing (Fig. When installed, the distance between the hood and burners must be not less than 43 cm for electric burners or 65 cm for gas or mixed-fuel burners. Children should not be allowed to tamper with the controls or play with the appliance. Do not use the cooker hood where the grill is not correctly fixed!The suctioned air must not be conveyed in the same channel used for fumes discharged by appliances powered by other than electricity. The environment must always be adequately aerated when the cooker hood and other appliances powered by other than electricity are used at the same time. flambé cooking with a cooker hood is prohibited. The use of a free flame is damaging to the filters and may cause fire accidents, therefore free flame cooking must be avoided. The hood can be installed beneath cabinets with varying depths. Adjustments for opening and closing the drawer can be made based on your specific needs. For the best performance, we recommend using the low speeds in normal conditions and the high speeds when strong odour and vapour concentrations are present. We recommend starting the hood a few minutes before cooking and keeping it running for at least 15 minutes until all the odours have been eliminated. Open the light cover support or the back grease filter support grate. Always replace burnt-out lamps, according to what is provided for your appliance, with olive-shaped max. Close the light cover support or the back grease filter support grate. Before calling for customer service because the lighting system does not work, make sure that the lamps are screwed in tightly. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Therefore, we recommend observing these instructions. [. . . ] Before calling for customer service because the lighting system does not work, make sure that the lamps are screwed in tightly. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Therefore, we recommend observing these instructions. Before performing any maintenance, disconnect the hood from the electrical supply. [. . . ]