User manual SMEG M2

[. . . ] Avoid touching the hot areas during this time. Child safety Your hob has a child safety feature which locks it when it is off or during cooking (see section: use of child safety). Do not forget to unlock before using again. For users with heart pacemakers and active implants. The functioning of the hob conforms to current electromagnetic interference standards and thus is in total compliance with legal requirements (2004/108/CE directives). In order to avoid interference between your cooking hob and a pacemaker, your pacemaker must be designed and programmed in compliance with the regulations that apply to it. Consequently, we can only guarantee that our own product is compliant. [. . . ] Your appliance should be positioned so that the mains switch is accessible. When power is first supplied to your hob, or after an extended power cut, an indicator light will appear on the control panel. Wait for 30 seconds approximately until this information disappears before using your hob (This display is normal and it is intended, if applicable, for your after-sales service. In all cases, the user of the hob should disregard it). Hook-up of 400V 2N ~ - 16A Separate the 2 phase wires (L1 and L2) before connection. Black-grey Brown Green/yellow Blue N Neutral L1 L2 Live Earth Warning If the cable is damaged it must be replaced by the manufacturer, its aftersales service or a person with a similar qualification to prevent danger. For a 400 V 2N triphase connection, if your hob malfunctions, check that the neutral conductor is properly connected. Hook-up of 2x230V 2L+2N ~ - 16A Separate the wires before connection. Black-grey Hook-up of 220-240V ~ Green/yellow Brown Blue Green/yellow Black-grey Blue Brown N1 N2 L1 L2 N Neutral L Earth Live Neutral Live Earth 32A Hook-up of 400V 3 - 16A ~ 19 EN 2 / USING YOUR APPLIANCE DESCRIPTION OF THE WORKTOP 00016 16 cm 50 W - 2000 W 28 cm 6 50 W - 3600 W 21 cm 50 W - 2300 W SI 3633 00017 18 cm 50 W - 2300 W 21 cm 50 W - 2300 W 21 cm 50 W - 2300 W 16 cm 50 W - 2000 W SI 3644 20 2 / USING YOUR APPLIANCE EN COOKWARE FOR INDUCTION WHICH COOKING ZONE TO USE DEPENDING ON YOUR COOKWARE Cooking area* 16 cm Cookware to use 10 . . . . . 18 cm 12 . . . . . 22 cm 18 . . . . . 24 cm 12 . . . . . 32 cm C A + - 18 cm 21 cm 28 cm B A Inductor B Electronic board C Induced electric current *depending on model The induction principle The principle of induction is based on a magnetic effect. When you place your cookware on a cooking zone and you turn it on, the electronic boards in your cooking hob produce "induced" currents in the bottom of the cookware and instantly raise its temperature. This heat is then transferred to the food, which is simmered or seared depending on your settings. Tip To check the suitability of your cookware: Place the pan on a cooking zone at power level 4. If the display remains on, your cookware is compatible. If the display flashes, your cookware cannot be used with induction cooking. You can also use a magnet to test the cookware. If a magnet "sticks" to the bottom of the cookware, it is compatible with induction. Cookware Most cookware is compatible with induction. Only glass, terra cotta, aluminium without a special finish on the bottom, copper and some non-magnetic stainless steels do not work with induction cooking. When you press the power or timer keys of the zones in operation, the LED of the lock lights; it will go out after a few seconds, Only the "stop" button is always active In the cooking zones which are not in operation, the symbol and the LED light when o you press the "on/off" buttons. This display disappears after a few seconds, The hob is locked when switched off The LED above the lock key is unlit. Pressing this button for a short time causes the LED to light. The LED is displayed when you press an on/off button in any zone. How to unlock Press the unlock button until the LED goes out and a double sound signal confirms your operation. 23 EN 2 / USING YOUR APPLIANCE SAFETY MEASURES DURING OPERATION Residual heat After intensive use, the cooking zone that you have just used can remain hot for several minutes. H An "H" is displayed during this period. Avoid touching the hot areas during this time. Protection against spills EP P. . BE BEE The hob may shut down (with the adjacent symbol in the display) and a beep (depending on the model) may sound in any of these 3 situations: Temperature limiter Each cooking zone is equipped with a safety sensor that constantly monitors the temperature of the bottom of the cookware. Never place items wrapped in aluminium foil or packaged in aluminium dishes on your cooking hob. The aluminium will melt and permanently damage your cooking appliance. Objects not intended for cooking should never be placed on the hob (risk of powering on, scratches, etc. ). The steam jet could damage your hob. MAINTAINING YOUR APPLIANCE TYPES OF STAINS/SPOTS Light. Thoroughly moisten the zone to be cleaned with hot water, then wipe off. [. . . ] or is displayed. Call the After-Sales Service Department. See chapter on using the child safety system. While in use YOU OBSERVE THAT: POSSIBLE CAUSES: WHAT SHOULD YOU DO? Clean the hob or remove the object, then begin cooking again. The hob has stopped operating and is There was an overflow or an beeping approximately every 10 sec- object is in contact with the onds and a or F7 is displayed. or F7 is dis- The electronic boards heated up. After turning on a heating zone, the The cookware used is not suitindicator lights on the control panel able for induction or is less continue to flash. [. . . ]