User manual SMEG OFGG7GVXA

[. . . ] PRECAUTIONS FOR USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . INSTALLING THE APPLIANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ADAPTATION TO DIFFERENT TYPES OF GAS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . FINAL OPERATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] FINAL OPERATIONS After changing the nozzles, put the pan stands, the burner caps and flame diffuser rings back in place. After adjusting for use of a gas other than the gas used for testing the appliance, replace the gas setting label on the appliance with the label for the new gas. The label is supplied in the bag with the nozzles. 4. 1 Regulation of the hob burner minimum level for natural gas Light the burner and turn it to the minimum position . Extract the gas tap knob and turn the adjustment screw at the side of the tap rod until the correct minimum flame is achieved. Refit the knob and verify that the burner flame is stable (turning the knob rapidly from the maximum to the minimum position the flame must not go out). Repeat the operation on all the gas taps. For models with valves, keep the knob at minimum level for about 1 minute to keep the flame lit and to activate the safety device. 4. 2 Regulation of the hob burner minimum level for ULPG In order to adjust the minimum with ULPG, the screw at the side of the tap rod must be turned clockwise all the way. The bypass diameters for each individual burner are shown in paragraph "3. 2 Burner and nozzle characteristics table". Once the regulation has been completed, restore the seal on the bypasses using paint or similar materials. 4. 3 Adjustment of the oven burner minimum Light the burner and turn it to the minimum position . Extract the gas tap knob and turn the adjustment screw at the side of the tap rod until the correct minimum flame is achieved. Refit the knob and verify that the burner flame is stable (turning the knob rapidly from the maximum to the minimum position the flame must not go out). Repeat the operation on all the gas taps. 13 Instructions for the user 5. GETTING TO KNOW YOUR COOKER HOB CONTROL PANEL omega 55 50 45 40 35 30 25 0 5 10 15 20 150 175 125 2 200 225 250 OVEN/MAIN OVEN 275 FOOD WARMER COMPARTMENT 3 4 14 Instructions for the user 6. DESCRIPTION OF FRONT PANEL CONTROLS All the cooker controls are grouped together on the front panel. The symbols used are described in the table below. omega 55 50 45 40 35 30 25 5 10 15 20 125 150 175 200 225 250 275 OVEN THERMOSTAT KNOB OVEN FUNCTIONS KNOB TIMER KNOB FRONT LEFT-HAND BURNER REAR LEFT-HAND BURNER CENTRAL BURNER REAR RIGHT-HAND BURNER FRONT RIGHT-HAND BURNER HOB BURNERS CONTROL KNOB To light the flame, press the knob and turn it counterclockwise to the minimum flame symbol . To adjust the flame, turn the knob to the zone between the maximum ( ) settings. To turn off the burner, turn the knob to the position. ) and minimum ( TIMER KNOB In order to use the timer, the buzzer must be set by turning the knob in a clockwise direction. The numbers correspond to minutes (maximum 55 minutes). Adjustment is progressive and intermediate positions between the figures can be used. The end of cooking buzzer does not interrupt operation of the oven. GAS OVEN THERMOSTAT KNOB This knob allows the gas burner inside the oven to be lit. The cooking temperature is selected by turning the knob counterclockwise to the desired setting, between 125°C. To learn how to light the gas oven, see paragraph "8. 3 Using the gas oven". 15 Instructions for the user 4 FUNCTIONS SELECTION KNOB This control lets you access the various functions of the oven. [. . . ] Take out all removable parts. Clean the oven grill and side guides with hot water and non-abrasive detergent. Rinse and dry. 10. 7 Cleaning the door glazing The glass in the door should always be kept thoroughly clean. Use absorbent kitchen roll; remove stubborn dirt with a damp sponge and ordinary detergent. When cleaning, dry the appliance thoroughly to prevent water or detergent drips from interfering with its operation or creating unsightly marks. [. . . ]