User manual SMEG OMW24B1

[. . . ] The route of the flue must be as short as possible. Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc. ). If the extractor is used in conjunction with non-electrical appliances (e. g. [. . . ] gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has been designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. Do not flamb under the range hood; risk of fire This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. MAINTENANCE Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Remove possible charcoal filters. 150 9 120 RECIRCULATION VERSION AIR OUTLET Cut a hole 125 mm in any shelf that may be positioned over the hood. Insert the reducer flange 9 on the hood body outlet. Connect the flange to the outlet on the shelf over the hood by using a flexible or rigid pipe 120 mm. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the air outlet grid 8 on the recirculation air outlet by using the 2 screws 12e (2, 9 x 9, 5) provided. Ensure that the activated charcoal filters have been inserted. 12e 8 125 9 ELECTRICAL CONNECTION Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. . EN 1 13 3 USE 01 01 123 L M V L M V Light Motor Speed Switches the lighting system on and off Switches the extractor motor on and off Sets the operating speed of the extractor: 1. Low speed, used for a continuous and silent air change in the presence of light cooking vapour. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio. [. . . ] Low speed, used for a continuous and silent air change in the presence of light cooking vapour. Medium speed, suitable for most operating conditions given the optimum treated air flow/noise level ratio. Maximum speed, used for eliminating the highest cooking vapour emission, including long periods. EN 1 14 4 MAINTENANCE Grease filters CLEANING METAL SELF- SUPPORTING GREASE FILTERS The filters must be cleaned every 2 months of operation, or more frequently for particularly heavy usage, and can be washed in a dishwasher. [. . . ]