User manual SMEG PSD193SE

[. . . ] 26 Switching a cooking zone off automatically. 43 Safety instructions for installation . 52 3 Guide to the appliance Hob abcde Cooking zones Sensor switches Control panel f For setting the power level g Booster h Sensor for setting the timer, changing between functions, and selecting a cooking zone j Safety lock k For setting the time/ Selecting a memory programme l Hob ON/OFF m Memory function Indicator lamp for i Safety lock 4 Guide to the appliance Cooking zone display n Displays: 0 = 1 to 12 = # = ß = F A P0 etc. = = = = Cooking zone ready for use Power levels Residual heat No pan on cooking zone or pan unsuitable (see "Induction") Fault (see "Safety switch-off") Auto heat-up when the power level range has been extended Programme (see "Programming") Status (see "Programming") o Indicator lamp for extending the power level range (see "Programming") p Light-ring: The number of curved lines lit up equates to the power level chosen (exception: see "Cooking with Auto heat-up") q This segment lights up when a booster is engaged 5 Guide to the appliance Timer/Memory display r Indicator lamp for relevant zone, e. g. [. . . ] If a power level is selected before the booster function is switched on, the zone will revert to this pre-selected power level when the booster is switched off, or automatically at the end of the booster time. 24 Use Switching off and residual heat indicators To switch off a cooking zone: ^ Touch the - and + sensors for the zone you want to switch off at the same time. A 0 will light up in the display for that zone for a few seconds. If the cooking zone is still hot, residual heat will then be indicated in the display. The lines of the residual heat indicator go out one after another as the cooking zones cool down. The last horizontal line only goes out when the cooking zone is safe to touch. The residual heat indicators also react to hot dishes and plates being placed on a cooking zone that is not switched on. Do not touch any zone or place any heat sensitive items on a zone where the residual heat indicators are lit up. Danger of burning. To switch off the hob: ^ Touch the ON/OFF sensor s. The residual heat indicator will appear in the display of any cooking zone which is still hot. 25 Timer and Memory function Introduction The hob is fitted with: - Minute minder (Timer function) - Automatic switch-off for the cooking zones (Timer function) - Memory function. These functions are described one by one on the following pages. The Combi mode is described in the section of that name. Up to 5 of your favourite cooking processes can be saved as Memory programmes. However, only one programme can be recorded or used at any one time. Memory programmes can be recorded on any of the cooking zones. Each cooking zone can have more than one programme recorded on it. Programme slots that have settings memorised to them are indicated by a dot after the number, for example: P 1 Nothing saved in memory P 1. If all programme slots are occupied and you want to save a new cooking process, you will first have to delete one of the existing programmes. Recording a Memory programme The maximum time that can be recorded is 99 minutes with a maximum of 10 changes in power level. P 1 will show in the Timer/Memory display. ^ Touch the + sensor until the programme number you require shows in the display. ^ Touch the M sensor until a long audible tone sounds. ^ Within 10 seconds of this, switch on the cooking zone required. [. . . ] Any gap between the frame and worktop will reduce with time. Installing the hob ^ Feed the hob connection cable down through the cut-out. ^ Place the hob centrally in the cut-out. When doing this make sure that the seal under the hob sits flush with the worktop on all sides. [. . . ]