User manual SMEG PU64ES

[. . . ] DANGER identifies the most serious hazards. It means you can be killed or seriously injured if you do not immediately follow instructions. WARNING means you can be killed or seriously injured if you do not follow instructions. CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. [. . . ] As long as they are heat resistant (T = 90°C - 194° F). Observe all governing codes and ordinances. Do not obstruct flow or combustion and ventilation air. It is the installer's responsibility to comply with installations guidelines specified on the model/serial rating plate. The model/serial rating plate is located on the underside of the cooktop burner box. The cooktop should be installed in a location away from strong draft areas, such as windows, doors and strong heating vents or fans. All openings in the wall or floor where cooktops is to be installed must be sealed. Cabinet opening dimensions that are shown must be used. Given dimensions are minimum clearances. See "Electrical Requirements" section. Proper gas supply connection must be available. Line pressure testing: Testing above 112 PSI (3. 5 kPa), with water column of 14" (35. 6 cm) (gauge). The cooktop and its individual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures greater than 1/2 psig (3. 5 kPa). Testing below 112 PSI (3. 5 kPa) with a water column of 14" (35. 6 cm) (gauge) or lower. The cooktop must be isolated from the gas supply piping system by closing the respective manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psig (3. 5 kPa). If the appliance is installed on an oven, the gas pipe must not pass along the back of the oven, as this may cause overheating. 4) 5) 6) 3. 2 Electrical requirements ELECTRICAL SHOCK HAZARD Plug into a grounded 3-prong outlet. Failure to follow these instructions can result in death, fire, or electrical shock. WARNING - - lf codes permit and a separate ground wire is used, it is recommended that a qualified electrician checks that the ground path is adequate. Check with a qualified electrician if you are not sure whether the cooktop is properly grounded. A 120-volt, 60-Hz, AC-only, 15-ampere, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided. - - 9 Instructions for the Installer 3. 2. 1 Recommended Grounding Method For your personal safety, this cooktop must be grounded. This cooktop is equipped with a 3-prong ground plug. [. . . ] If flexible metal conductor is used, be certain tubing is not kinked. Use only pipes (E) conforming to standard regulations in force, inserting gasket B (supplied) between fitting A adaptator C. The adaptor C must be fitted on the gas connection A before fixing the hob. Always place a suitable sealing medium (such as Teflon tape) between pressure regulator D and adaptator C and between pressure regulator D and pipe E. 7) 8) Plug power supply cord into grounded outlet. 13 Instructions for the Installer 5. [. . . ]