User manual SMEG S399X-6

[. . . ] INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 29 INSTALLATION _________________________________________ 31 DESCRIPTION OF CONTROLS ____________________________ 34 USE OF THE OVEN ______________________________________ 40 AVAILABLE ACCESSORIES _______________________________ 42 COOKING HINTS ________________________________________ 43 CLEANING AND MAINTENANCE ___________________________ 47 EXTRAORDINARY MAINTENANCE _________________________ 52 INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. 28 Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE OVEN. [. . . ] Set the cooking duration time as described in the previous point. Within 6/7 seconds after the last time the or keys are key to set the cooking start time. The display pressed, press the will show the current time with the inside segments indicating the cooking end time illuminated. Use the and keys to set the cooking start time. 6/7 seconds after the last time a key is pressed, the display will show the current time and the cooking start and end times, indicated by the illuminated inside segments. The segments on the display will be constantly on until the current time is the same as the cooking start time; as soon as the current time reaches the cooking start time set, all the inside segments will start to flash, indicating that the oven has started cooking. When the end of the cooking time is reached, the timer will switch off the oven heating elements, the beeps will start and the numbers on the dial will flash. To reset the entire program set, keep the central key pressed for 1 or 2 seconds: if cooking has already started the oven will have to be switched off by hand. The image on the right shows an example of programming: the current time is 7. 06 and cooking is programmed to start at 8 o'clock and finish at 9. At 8 o'clock, the inside segments between 8 and 9 will start to flash and the hour pointer will remain still. Caution: for the oven to start cooking after the programming procedure just described, the thermostat and function selector must be properly set on the temperature and function required. 3. 2. 4 "DEMO" Function Models with analogue/digital programmer feature a "DEMO" function which deactivates the heating elements while leaving the other functions unchanged. To activate it, simply press the , and keys for 3/4 seconds. A confirmation beep will inform the user that the function is active. To deactivate it, simply repeat the same procedure. - 39 Instructions for the user 4. USE OF THE OVEN In models equipped with analogue digital timer, the user has only to press the central key for 1/2 seconds to enable use of the oven on first use or after a power blackout. 4. 1 Warnings and general advice Before using the oven for the first time, pre-heat it to maximum temperature long enough to burn any manufacturing oily residues which could give the food a bad taste. During cooking, do not cover the bottom of the oven with aluminium or tin foil and do not place pans or oven trays on it as this may damage the enamel coating. Pastry plate: for baking cakes, pizza and oven desserts. Roof liner/Grill guard: removing this simplifies cleaning procedures inside the oven. Some models do not feature all accessories. Accessories available on request Original accessories may be ordered from any Authorised Service Centre. 42 Instructions for the user 6. [. . . ] Extract the side liners "F" and "G"(fig. Remove the back panel "A" after undoing the threaded ring-nut "C" (fig. Reassemble the panels, restoring them to their original position. 1) 2) 48 Instructions for the user 7. 3 Removing the door 7. 3. 1 Removing doors with mobile hinges With the door completely open, lift the levers A until they touch the hinges B and take hold of the two sides of the door with both hands close to the hinges. Raise the door to an angle of about 45° and remove it. [. . . ]