User manual SMEG S3L090P

[. . . ] Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance. If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. • Do not install this appliance in areas that are too humid or too colds, such as the construction appendices, garages or wine cellars. • When you move the appliance, lift it by the front edge to avoid scratching the floor. SAFETY INSTRUCTIONS Installation WARNING!Only a qualified person must install this appliance. [. . . ] • Remove the door to prevent children and pets to be closed inside of the appliance. • The refrigerant circuit and the insulation materials of this appliance are ozonefriendly. • The insulation foam contains flammable gas. Contact your municipal authority for information on how to discard the appliance correctly. • Do not cause damage to the part of the cooling unit that is near the heat exchanger. Internal light • The type of lamp used for this appliance is not suitable for household room illumination OPERATION Switching on 1. Turn the Temperature regulator clockwise to a medium setting. 16 Switching off To turn off the appliance, turn the temperature regulator to the "O" position. Temperature regulation The temperature is regulated automatically. A medium setting is generally the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: • room temperature, • how often the door is opened, • the quantity of food stored, • the location of the appliance. 1. Turn the Temperature regulator toward lower settings to obtain the minimum coldness. Turn the Temperature regulator toward higher settings to obtain the maximum coldness. If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. FIRST USE Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. DAILY USE WARNING!Refer to Safety chapters. Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Do not move the glass shelf above the vegetable drawer and the bottle shelf to ensure correct air circulation. 17 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. Gradually pull the shelf in the direction of the arrows until it comes free. Reposition as required. The symbol on the side wall of the appliance indicates the coldest area in the refrigerator. If “OK” is displayed (A), put fresh food into area indicated by symbol, if not (B), adjust the temperature controller to a colder setting and wait 12 hours before checking the temperature indicator again. A OK OK After putting fresh food into the appliance or after opening the door repeatedly or for a long period, it is normal for the indicator not to show "OK"; wait at least 12 hours before readjusting the temperature controller. B Temperature indicator For proper storage of food the refrigerator is equipped with the temperature indicator. HINTS AND TIPS Normal operating sounds The following sounds are normal during operation: • A faint gurgling and bubbling sound from coils sound when refrigerant is pumped. • A whirring and pulsating sound from the compressor when refrigerant is pumped. • A sudden cracking noise from inside appliance caused by thermic dilatation (a natural and not dangerous physical phenomenon). • A faint click noise from the temperature regulator when the compressor switches on or off. • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption. Hints for fresh food refrigeration To obtain the best performance: • do not store warm food or evaporating liquids in the refrigerator • do cover or wrap the food, particularly if it has a strong flavour • position food so that air can circulate freely around it Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. 18 Hints for refrigeration Useful hints: • Meat (all types) : wrap in polythene bags and place on the glass shelf above the vegetable drawer. [. . . ] If you have any doubts regarding where to install the appliance, please turn to the vendor, to our customer service or to the nearest Authorised Service Centre. Electrical connection • Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. +10°C to + 32°C +16°C to + 32°C 22 • The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. • The manufacturer declines all responsibility if the above safety precautions are not observed. • This appliance complies with the E. E. C. [. . . ]