User manual SMEG S600EB

[. . . ] Remove the blue protective film from the panel (depending on model). · After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer. [. . . ] Replace the siphon caps in the dispenser (if removed). Replace the dispenser by locating the bottom tabs in the lid holes and pivot until both of the upper buttons lock. Note: ensure that the detergent dispenser is correctly reinstalled. GB 10 Water inlet hose filter Check and clean regularly (at least two or three times a year). Carefully clean the filter located at the end of hose, without assembling it, for example with a tooth-brush. Note: For machines equipped with hose type "A", it must not be submerged in water. Screw the flexible hose back onto the tap by hand. Do not use pliers (risk of squashing the joint). Turn on the tap and check that the connections are watertight. Plug the washing machine back in. A Recovering an object that falls between the drum and the tub If an object accidentally falls between the drum and the tub, you can recover it thanks to one of the removable drum blades: 1. Close the drum flaps and turn the drum a half-turn. Using the screwdriver press the plastic end while sliding the blade from left to right. · the foreign body trap in the water inlet hose is not blocked (see "Care and maintenance"). *Insufficient or no water supply. Switch off the washing machine and unplug it. Check whether: · the water tap is fully turned on, and the water supply pressure is sufficient. · the water inlet hose is kinked. · the mesh filter in the water inlet hose is blocked (see "Care and maintenance"). · the water in the water inlet hose is frozen. · the washing machine has a safety hose and the safety valve is open (red indicator in the safety valve inspection window). In this case replace it with a new safety hose. *The washing machine vibrates during the spin cycle. Check whether: · the washing machine is levelled and all the feet are adjusted (see "Installation"). · the transport bracket has been removed. Before starting up the washing machine, the transport bracket MUST be removed (see "Installation"). GB 12 *Final spin results are poor. Note: the washing machine has an unbalance detection and correction system. If individual heavy items are loaded (a bathrobe, for example), this system may reduce the spin speed automatically or interrupt the spin if it detects too great unbalance at the start of the spin, in order to protect the washing machine. Water stop fault (depending on model). (The pump operates). The "Water Stop" fault may have been triggered by: · Too much foam. [. . . ] · This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: the programme selector knob stops on . Appliance in "Rinse Hold": · Press the "Rinse Hold" button again: the programme will terminate automatically with the selected spin cycle. · If you do not wish to spin the clothes, press the "On/Off" button, turn the programme selector knob to the "Drain" programme and press the "On/Off" button again. [. . . ]