User manual SMEG S809AD

[. . . ] INSTALLATION MUST BE CARRIED OUT BY QUALIFIED STAFF IN COMPLIANCE WITH THE RELEVANT REGULATIONS. THIS OVEN IS INTENDED FOR PROFESSIONAL USE AND COMPLIES WITH THE EEC DIRECTIVES CURRENTLY IN FORCE. THE APPLIANCE IS BUILT TO PROVIDE THE FOLLOWING FUNCTION: COOKING AND HEATING FOODS; ALL OTHER USES ARE TO BE CONSIDERED IMPROPER. THE MANUFACTURER DECLINES ALL LIABILITY FOR USES OTHER THAN THOSE STATED ABOVE. [. . . ] To set the current time, hold down START + STOP together until the display stops flashing. Now press START to increment the hour display. Once the current hour has been set, press STOP to set the minutes and increment them as before by pressing the START button. When the correct time is set, press the STOP button and the display will stop flashing. 27 Instructions for the User 4. 3 Program selection This oven has 10 different cooking programs, including: 2 preset programs (P1 ­ P2); 6 user-editable programs for humidified fan-mode cooking (P3 to P8), 1 preheating program with user-editable temperature and start and end time (P9), 1 "easy" editable program for humidified fan-mode cooking (P10). The following table shows the parameters for each program. Uprh preheating temperature 210 °C 240 °C Editable Editable Editable Editable Editable Editable Editable Same as edited Ut°C Ut °C cooking temperature 210 °C 240 °C Editable Editable Editable Editable Editable Editable N/A Editable U Ct cooking time 18 minutes 9 minutes Editable Editable Editable Editable Editable Editable N/A Editable Program start/end time N/A N/A N/A N/A N/A N/A N/A N/A Editable N/A H2O 5, 0 5, 0 Editable Editable Editable Editable Editable Editable N/A Editable P1 P2 P3 P4 P5 P6 P7 P8 P9 P10 4. 4 Presettings Programs The first two program selector knob settings are for the presetting cooking mode programs. Use the knob to select one of the preset programs (P1­P2). The display shows the parameters of the selected program (cooking time; temperature in degrees Centigrade, program number and steam percentage in the cooking chamber, e. g. P1). Press START to confirm the start of the program. The program starts, performing the preheating stage; the display shows "PrEh". When the preheating is complete, a "BEEP" sounds to indicate that cooking can start. Press START to display the cooking time. Press START or keep it pressed to increase the cooking time (from 1 min. Press STOP to move on to displaying the next parameter The display shows H2O. Press START to increase the number of seconds of water infeed per minute (from 0 to 5 where 0 means conventional fan-mode cooking without the aid of humidification). Press STOP to complete the editing operation. The parameters set are now saved in the chosen program. Press START to display the parameters just set. Press START again to run the program just edited. 30 Instructions for the User 4. 7 Modifying a previously edited program To modify one of the programs, turn the knob to one of the programs from P4 to P8 edited previously. The parameters saved earlier will appear on the display. Press START to increase the pre-heating temperature. Press STOP to move on to displayng the next parameter. [. . . ] Press START or keep it pressed to increment the hours. Press STOP to move on to setting the minutes. 31 Instructions for the User Press START to increment the minutes. Press STOP to move on to displaying the next parameter. [. . . ]