User manual SMEG S9GMXU

[. . . ] The appliance can be used in both the filtering and ducting version. 1), the air and vapours conveyed by the appliance are depurated by carbon filters and recirculated around the room through the air vents of the flue. ATTENTION: When using the Filtering version, two carbon filters must be installed plus an air switch A (Fig. Positioned in the upper part of the structure, this allows the air to be recirculated throughout the room. [. . . ] Fix the telescopic structure to the ceiling using the larger diameter washers and screws, together with the screw anchors supplied with the hood, after having made the air hole and installed the wiring system within the upper telescopic flue. Adjust the height of means of the four Remember that the and that it must be hob (Fig. Hood is 345 mm in height at least 650 mm from the USE --------------------------------------------------Avoid using materials which could cause spurts of flame (flambées) near the appliance. When frying, take particular care to prevent oil and grease from catching fire. Already used oil is especially dangerous in this respect. To avoid possible risks of fire always comply with the indicated instructions when cleaning anti-grease filters and when removing grease deposits from the appliance. INSTALLATION --------------------------------------------------It is advised to follows carefully all the assembling steps and to make sure, once the assembling operation is over, that the appliance is fixed steadily; it is moreover advised to have skilled workers to assemble it. Remove the anti-grease filters before proceeding with the assembly instructions. This will make the appliance easier to handle. to remove the anti-grease filters (Fig. 3): this is carried out by pushing the relative catch inwards and turning it downwards until it disengages from the supports. Remove the two screws used to temporarily fix the lower telescopic flue, positioning it definitively on the hood and fixing it with the two screws B (Fig. INSTALLING THE FILTERING VERSION: To allow the air to recirculate around the room through the stack vents, the telescopic structure must be preset in the following way: Remove the four screws D (Fig. 4) from the structure and separate the upper part from the lower part. Fix a suitable pipe to the supplied air baffle union flange (Fig. Insert the filtering baffle complete with flue into the upper structure so that the air outlets match openings A (Fig. Now fix the parts in place with the four screws B (Fig. Fit the upper and lower parts of the telescopic structure together again (Fig. Using the relative boring template, make holes in the ceiling in alignment with your hob. The side of the structure with opening B (Fig. 4) must always point towards a short side of the hood. Fix the telescopic structure to the ceiling using the larger diameter washers and screws, together with the screw anchors supplied with the hood, after having installed the wiring system within the upper telescopic flue. [. . . ] 6) and temporarily resting the flue on these. During this operation, check that the fixing holes C (Fig. 6) of the lower telescopic flue point downwards. Fix the hood to the lower plate of the telescopic structure using the four supplied nuts and relative washers (Fig. [. . . ]