User manual SMEG SA435X-1

[. . . ] Switch on the plates by turning the knob to the required position. A diagram is screen-printed on the front panel. This diagram indicates to which electric plate the knob in question corresponds (see fig. [. . . ] This will keep the surface of the plate clean and bright. The operation will also prevent the formation of rust. - Any liquid overflowed the pans, must be always remove with a rag. - Don't use steam jets for the equipment cleaning. FIG. 3 4 INSTALLATION Installation and maintenance must only be carried out by a qualified technician. Incorrect installation could cause damage to persons, property and animals for which the manufacturer cannot be held responsible. Check that the appliance is in a good condition after having removed the outer packaging and internal wrappings from around the various loose parts. If in doubt, do not use the appliance and contact qualified personnel. Never leave the packaging materials (cardboard, bags, polystyrene foam, staples, etc. ) within children's reach since they could become a potential source of danger. - Evenly and securely fix the seal to the hob, pressing it into place with the fingers. - Remove the strip of protective paper from the seal. Fit the hooks into their relative housings in the unit and set the hob into the hole in the cabinet. Lock it in place with the fixing screws "G" (see fig. Barrier installation CAUTION: THE UNDERSIDE SURFACE OF THE COOKING HOB CAN REACH A TEMPERATURE EXCEEDING 95°C DURING NORMAL USE. IF AFTER INSTALLATION THE UNDERSIDE SURFACE IS ACCESSIBLE THROUGH UNDERBENCH CUPBOARD DOORS AND THE LIKE, IT IS ESSENTIAL THAT A RIGID BARRIER IS INSTALLED SO THAT SUCH ACCESS IS RESTRICTED. IN ORDER TO AVOID A HAZARD THE BARRIER MUST BE OF LOW THERMAL CONDUCTIVITY MATERIAL (eg wood) INSTALLED ACCORDING TO THE FOLLOWING INSTRUCTIONS. The barrier must have at least 28 Ø 70mm holes cut into it. The barrier should be positioned directly under the cooking hob at least 50mm away from the base of the unit. [. . . ] 9 6 SERVICING Always disconnect the appliance from the electricity main before proceeding with any servicing operation. longer than "live" ones, and must respect the cautions in paragraph "Electrical connection". To reassemble the appliance repeat the inverse process. 8) REPLACING THE ELECTRICAL COMPONENTS For access to the various parts, remove the hotplate from the top of the cabinet. [. . . ]