User manual SMEG SBC30

[. . . ] Cooking zones are aesily identifiables thanks to the circles (see illustration in description) on the top; relative powers are listed in the scheme n. 1. On the frontal panel, close to each knob, has been silk-screened a scheme where is indicated to which cooking zone the knob refers (fig. In some particular models the scheme annexes a light indicator that turns on when the cooking zone temperature is above 60° C. The indicator will turn off only when the temperature of the cooking zone will be below the value: this is the reason why we call it residual heat indicator. [. . . ] - After a period of time may appear metal reflex and scratches (fig. 4) due to the wrong cleaning and the wrong use of the pots. The scratches are difficultly removable, but they do not compromise the good working of the hob. - Don't use steam jets for the equipment cleaning. FIG. 4 22 INSTALLATION TECHNICAL INSTRUCTIONS FOR THE INSTALLER Installation, transformations and maintenances below listed, may only be carried out by a competent technician. A wrong installation may provoke damages to persons, animals or things, for which the builder can not be responsible. Please keep children away from all packing elements ( carton, polystyrene, nails, . . ). Make a cutout in the worktop, according to the dimensions indicated in fig. 5 and 6; make sure that will be respected the critical dimensions of the space in which the appliance has to be installed (fig. 5 - 6 and 7). 3) INSERTING After having cleared out all the packing components, make sure of the integrity of the appliance. COMPLY WITH THE DIMENSIONS (mm) A EL. HOB 70 B 485 475 475 C 60 65 62. 5 D 60 65 E 60 min. 100 min. 285 555 653 62. 5 123 min. FIG. 7 23 INSTALLATION 4) FIXING A special sealing strip underneath the hob for damage. Make sure it is correctly positioned with no gaps; it avoids any water infiltration. To fix in the right way the strip, please, respect the following instructions: - Fix the hooks in the relative accomodations of the body (see fig. - Overturn the hob, take the seal strips off from their support, having care that the transparent protection remains attached to the seal. Correctly place the seal "E" (fig. 10) under the hob edge, so that the external side of the seal fits together with the external perimentrical edge of the hob. The ends of the strip must fit together without overlapping. - Stick the seal to the hotplate uniformly, pressing it with fingers. - Take the protective paper strip of the seal off, place the hotplate in the opening made in the table top, and lock it with the special screws "F" (fig. WARNINGS: Be aware that the glue that join the laminated plastic to the furniture, has to resist to temperature not below 150° C, to avoid the unstuck of the panelling. The installer should bear in mind that the mixed appliance is the Y type. [. . . ] Rating 230 ­ 240 V ~ 50/60 Hz 3000 W 29 TECHNICAL ASSISTANCE AND SPARE PARTS This appliance, before leaving the factory, has been carefully tested and regulated by expert and specialized personnel in order to guarantee the best performances. Any repairs or adjustments which may be subsequently required may only be carried out by qualified personnel with the utmost care and attention. For this reason, always contact your Dealer or your nearest After Sales Centre whenever repairs or adjustments are required, specifying the type of fault and the model of appliance in your possession. Please also note that genuine spare parts are only available from our After Sales Service Centres and authorized retail outlets. [. . . ]