User manual SMEG SC378MFX

[. . . ] INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 30 INSTALLATION _________________________________________ 32 DESCRIPTION OF CONTROLS ____________________________ 35 USE OF THE OVEN ______________________________________ 41 AVAILABLE ACCESSORIES _______________________________ 42 COOKING HINTS ________________________________________ 43 CLEANING AND MAINTENANCE ___________________________ 48 ADDITIONAL MAINTENANCE ______________________________ 53 INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified technician who must install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user advice, description of the controls and the correct procedures for cleaning and maintenance of the appliance. 29 Introduction 1. INSTRUCTIONS FOR SAFE AND PROPER USE THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS THEREIN BEFORE USING THE OVEN. [. . . ] 3. 2. 7 Minute-counter The programmer can also be used as a simple minute counter. The use of the minute-counter will not interrupt oven operation at the end of the set time. 39 Instructions for the user , the display shows ; keep the key pressed or . By releasing the key , the and at the same time press keys programmed count starts and the symbols and appear on the monitor. After programming the minute-counter, the display will show the right time. Wrong settings are prevented logically (e. g. , any conflict between end of cooking time and a longer time will not be accepted by the programmer). By pressing key 3. 2. 8 Cancellation of set data Once the programme has been set, keep the key of the function to be cancelled pressed, while at the same time is reached by means of variation keys or . Time cancellation will be considered as endof-cooking time by the programmer. 3. 2. 9 Changing the set data The cooking data entered can be changed at any time by keeping the function key pressed and at the same time adjusting the keys or . 40 Instructions for the user 4. USE OF THE OVEN Before using the oven make sure that the electronic programmer displays the symbol (see "3. 2. 1 Clock adjustment"). 4. 1 Warnings and general advice Before using the oven for the first time, pre-heat it to maximum temperature (250°C) long enough to burn any manufacturing oily residues which could give the food a bad taste. In the models featuring an electronic programmer, a power failure causes the display to start flashing at regular intervals and the symbol to appear. To re-adjust, see "3. 2 Electronic programmer ". During cooking, do not cover the bottom of the oven with aluminium or tin foil and do not place pans or oven trays on it as this may damage the enamel coating. If you wish to use greaseproof paper, place it so that it will not interfere with the hot air circulation inside the oven. To prevent any steam in the oven creating problems, open the door in two stages: half open (5 cm approx. ) for 4-5 seconds and then fully open. To access food, always leave the door open as short a time as possible to prevent the temperature in the oven from falling and ruining the food. 4. 2 Cooling system (certain models only) The appliance is equipped with 2 cooling fans which come into operation when the oven is switched on. Fans cause a steady outflow of air from above the door which may continue for a brief period of time even after the oven has been turned off. 4. 3 Oven light To turn on the oven light in models with static oven, rotate the temperature knob clockwise to the first setting aligned with the lamp symbol ( ). The light will remain on throughout entire cooking operation. In the multifunction models, the inside oven light may be turned on by simultaneously rotating the function selector knob and the timer knob. When the oven is not working, the light comes on by simply opening the door. 41 Instructions for the user 5. AVAILABLE ACCESSORIES The oven features 4 support positions for shelves and pans of different height. Some models do not feature all accessories. Chrome shelf: useful for holding cooking vessels. Grill mesh: for placing above grill pan to allow juices to drip into pan below . Roasting/Grill pan: to be used for roasting or grilling. [. . . ] If the hinges have not locked, repeat the operation, raising the levers A and keeping the door slightly raised. To reassemble, fit the hinges B into their grooves, then lower the door into place, ensuring that it remains fitted into the grooves C, then lower the levers A. 7. 4. 2 Removing doors with pins Open the door completely and insert the pins (supplied) into the holes from the inside. Close the door to an angle of about 45° and lift it off. To reassemble, fit the hinges into their grooves, then lower the door into place and extract the pins. 50 Instructions for the user 7. 5 Removing the door glazing The glass in the door should always be kept thoroughly clean. [. . . ]