User manual SMEG SC709XU

[. . . ] UNDERSTAND SIGNAL WORDS A signal word ­ DANGER, WARNING, or CAUTION ­ is used with the safety-alert symbol. DANGER identifies the most serious hazards. It means you can be killed or seriously injured if you do not immediately follow the instructions. [. . . ] If this appliance is connected to an outside electrical power source, it must be grounded in compliance with local laws, or, if no local laws exist, in compliance with the national ANSI / NFPA 70 code of electrical regulations. Make sure that the voltage and dimensions of the supply line correspond to the information indicated on the model/serial rating plate. A multi-polar cut-out must be available on the supply line with a contact opening distance equal to or greater than 3mm, located in an easily accessible position near the appliance. Do not attempt to repair or replace any part of your oven unless it is specifically recommended in this manual. All other service procedures should be performed by a qualified technician. This oven is not suitable for installation and use in mobile homes or campers. See the "Electrical Requirements" section. It is the customer's responsibility: - To contact a qualified electrical installer, - To ensure that the electrical system is adequate and in compliance with the national ANSI / NFPA 70 ELECTRICAL CODE ­ latest edition ­ Or the CANADIAN ELECTRICAL CODE, C22. 11 ­ 1982 and C22. 2 No. 01982 ­ or latest edition ­ and all local codes and ordinances. IMPORTANT: Observe all government codes and ordinances. · · · · · 5 Instructions for the Installer 3. PREPARING THE BUILT­IN OVEN EXCESSIVE WEIGHT HAZARD WARNING - Use two or more people to move and install the oven Failure to do so can result in back or other injury. The oven is designed for installation into any type of cabinetry as long as it is heat-resistant. Proceed according to the dimensions shown in Pictures 1, 2 and 3. For installing under a countertop, follow the dimensions given in Picture 3. For installing under a countertop beneath a cooktop with controls connected to the oven, ensure a minimum clearance from any side walls of at least 110 mm as shown in Picture 1. For installing in a column, follow the dimensions given in Picture 2 allowing for a clearance of 80 to 90 mm at the top and sides of the column. For installing beneath a separate cooktop, allow for a rear and bottom clearance as shown in Picture 1 (ref. [. . . ] Connect the red and black leads from the oven to the corresponding leads in the junction box. fig. 1) US INSTALLATION AND CANADIAN INSTALLATION ­ 4 WIRE BRANCH CIRCUIT Refer to figure 2, Disconnect the green or yellow-green from the white lead. The ground wire must be connected first; Connect the green or yellow-green ground wire from the appliance to the ground in the junction box (green colored wire). [. . . ]