User manual SMEG SC712U

[. . . ] UNDERSTAND SIGNAL WORDS A signal word ­ DANGER, WARNING, or CAUTION ­ is used with the safety alert symbol. DANGER denotes the most serious hazards. It means you can be killed or seriously injured if you do not immediately follow the instructions. [. . . ] All other service procedures should be performed by a qualified technician. This oven is not suitable for installation and operation in mobile homes or recreational vehicles. See the "Electrical Requirements" section. It is the customer's responsibility: - To contact a qualified electrical installer, - To make sure that the electrical system is adequate and in compliance with the national ANSI / NFPA 70 ELECTRICAL CODE ­ latest edition ­ or the CANADIAN ELECTRICAL CODE, C22. 11 ­ 1982 and C22. 2 No. 01982 ­ or latest edition ­ and all local codes and ordinances. IMPORTANT: Observe all governing codes and ordinances. · · · · · 5 Instructions for the Installer 3. PREPARING THE BUILT­IN OVEN HEAVY WEIGHT HAZARD WARNING - Have two or more people move and install the oven Failure to do so can result in back injury or other personal injuries. The oven is designed for installation into any type of cabinetry as long as it is heat-resistant. Proceed according to the dimensions shown in Pictures 1, 2 and 3. For installing under a countertop, use the dimensions shown in Picture 3. For installing under a countertop beneath a cooktop with controls connected to the oven, ensure a minimum clearance from any side walls of at least 110 mm as shown in Picture 1. For installing in a column, observe the dimensions shown in Picture 2 allowing for a clearance of 80 to 90 mm at the top and sides of the column. For installing under a separate cooktop, allow for a rear and bottom clearance as shown in Picture 1 (ref. See instructions regarding fitting and securing the cooktop. It is important to follow these instructions before and during oven installation: · Decide on the final location of the oven. Locate the existing wiring to avoid drilling into or severing wiring during installation. · To avoid damage to the floor, place the oven on cardboard prior to installation. Do not lift by the door handle or any part of the frame or trim. [. . . ] Connect the red and black wires of the appliance cable to the matching power supply cables in the junction box. - UL/CSA listed wire connector pic. 1) U. S. INSTALLATION AND CANADIAN INSTALLATION ­ 4-WIRE GROUNDED JUNCTION BOX Refer to picture 2, Separate the green or yellow-green wires from the white wires that extend out of the end of the appliance cable. The ground wire must be connected first; Connect the green or yellow-green ground wire from the appliance to the grounded lead in the junction box (green wire). [. . . ]