User manual SMEG SCP495X-8

[. . . ] INSTRUCTIONS FOR USE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SAFETY PRECAUTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ENVIRONMENTAL RESPONSIBILITY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GET TO KNOW YOUR OVEN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The display will show and (flashing). Turn PT1 to the right or left to set the minutes of cooking (from 00:01 to 23:59). For reasons of safety, when setting programmed cooking the user must first program a cooking duration and then set the cooking start time. It is not possible to set the cooking start time only, without setting the cooking duration. After setting the duration, press PT1 once. and the current time will appear on the display. Turning PT1 to the right increases the time, allowing the cooking start time to be set. A few seconds after the desired duration is set, and will stop flashing and remain constantly on, and the oven will start to wait for the starting time set. At the end, the word STOP will appear on DSP1, cooking will stop and a buzzer will sound; press PT1 once to deactivate it. If you wish to continue cooking beyond the set time, press PT1 again. The oven will restart normal operation with the cooking settings selected previously. To switch the oven off completely, PT2 must be turned to 0. 66 Instructions for the user Modifying the set data Once programmed cooking has started, its duration can be changed. When and are steady and cooking is in progress, or the oven is in starts flashing and standby waiting for cooking to start, press PT1 once. PT1 can be turned to change the set duration. Press PT1 again; goes out, starts to flash, and the cooking start time will be displayed on DSP1. The cooking start time can be increased or decreased by turning PT1. A few seconds after the last change, and will appear (in steady mode) on DSP1 and programmed cooking will restart with the new settings. Once the desired function has been selected, the oven will begin cooking at the preset temperature. Cooking is preceded by a pre-heating phase (common to all functions) which allows the oven to reach the cooking temperature more quickly. This phase is indicated by pre-heating phase, flashing on the display (DSP1). At the end of the will remain constantly on to indicate that the food can be placed inside the oven. 7. 7. 4 Changing the preset temperature The preset temperature for each function can be changed to suit the user's requirements. At any time while cooking is in progress, turn PT1 in either direction to increase or decrease the cooking temperature by 5 degrees at a time. [. . . ] Remove the middle panes by lifting them upwards. (Multifunction models) · An intermediate glass panel may be present on multifunction models; if so, remove it by lifting it upwards. Cleaning: · Now it is possible to clean the external glass panel and the panels removed previously. In the case of stubborn dirt, wash with a damp sponge and neutral detergent. Replacing the glass panels: · Replace the panes in the opposite order to which they were removed. [. . . ]