User manual SMEG SE2731H

[. . . ] 44 Controls. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 Cleaning, maintenance and suggestions . . . . . . . . . . . . . 46 33 Installation advice Touch-control ceramic hobs are particularly sensitive electrical appliances. [. . . ] The hob is complete with a special adhesive seal «A» which prevents any infiltration into the unit. The seal must be carefully fixed around the edge of the opening for built-in mounting, pressing lightly with the hand to ensure that it sticks. Remove the paper protection and place the hob on the seal. The seal guarantees a waterproof finish and a perfectly smooth work top. Fix the hob to the unit using the brackets already fitted to the appliance. N. B. - The appliance must be installed by a skilled engineer in accordance with the regulations in force in your country. Always disconnect the appliance from the electricity supply before any adjustments, maintenance, etc. 36 Electrical connection Make sure that the mains electricity supply in the home is of the voltage and power indicated on the date plate underneath the hob. Use a cable of type H05RRF or H05RNF, bearing in mind that the earth wire (yellow-green) must be about 20 mm. Longer at the end for connection to the appliance. Make sure that the lead is not in contact with heated zones. On installation, provide an omnipolar circuit breaker with minimum distance between contacts at least 3 mm on the appliance power supply line, at a point easily reached from the appliance. Press the To switch off only the second element, press the button until the number 0 appears: then press the or button to resume single­element operation. F) To switch off the cooking zones, brush a finger over a control key, such as . button again to switch off all the G) Press the cooking zones, a blinking letter (H) will appear on and buttons (residual the displays above the heat). Control disabling key prevents any accidental The control disabling key operations while the hob is in use. The controls can be disabled during use (although operations already in progress continue and the relative settings can still be adjusted). To disable the controls Press the key; the lights beside the numbers will come on. To re-activate the controls key for 1-2 seconds and keep it pressed Press the until the light goes out. Switching off the cooking zones To switch off a cooking zone, press the corresponding 9 (ON/OFF) key. The display will go out and you will hear a short beep. 42 Safety cut-out device key switches off all cooking zones in operation The simultaneously, even if the controls have been cut out. key for about 2-3 seconds; the cooking Press the zones will go out after the beep. As long as the temperature of a cooking zone remains above 60°C, the associated display will continue to show a blinking letter (H). [. . . ] If they are smaller, energy will be wasted, and so larger pans should be used. The pan bottom and the glass surface must always be clean and dry. These rules are fundamental; failure to observe them will lead to loss of heat and thus wasted energy. 45 Cleaning, maintenance and suggestions Before doing any work, always disconnect the appliance from the electrical mains and read the following instructions carefully. The glass must be cleaned regularly after each use, when it is cold or still lukewarm. [. . . ]