User manual SMEG SE32X

[. . . ] This diagram indicates to which electric plate the knob in question corresponds (see fig. A red warning light will come on to indicate that the plate has been ignited. 2) HOW TO USE THE ELECTRIC PLATES A purely indicative plate regulation chart is given below. TABLE NORMAL AND RAPID PLATE 0 1 2 3 4 5 6 HEAT INTENSITY Off Weak Low Slow Medium Strong High To dissolve butter, chocolate, etc. . To prepare cremes and suces requiring long slow cooking times. To thaw frozen foods and prepare stews, heat to boiling point or simmer. [. . . ] Incorrect installation could cause damage to persons, animals and property for which the manufacturer cannot be held responsible. that the transparent protection still adheres to the seal itself. - Overturn the hob and correctly position seal "E" (fig. 5) under the edge of the hob itself, so that the outer part of the seal itself perfectly matches the outer perimetral edge of the hob. The ends of the strips must fit together without overlapping. - Evenly and securely fix the seal to the hob, pressing it in place with the fingers and remove the strip of protective paper from the seal and set the plate into the hole made in the cabinet. - Fix the hotplate to the worktop with the brackets "S". Ensure the tag fits into the hole "H" on the hotplate base, then tighten the screw "F" until it is locked to the worktop (fig. WARNINGS: be aware that the glue that join the laminated plastic to the furniture, has to resist to temperature not below 150° C, to avoid the unstuck of the panelling. The rear wall, adjacent and surrounding surfaces must therefore be able to withstand an overtemperature of 65K. 4) INSTALLING THE HOT PLATE Check that the appliance is in a good condition after having removed the outer packaging and internal wrappings from around the various loose parts. In case of doubt, do not use the appliance and contact qualified personnel. Never leave the packaging materials (cardboard, bags, polystyrene foam, nails, etc. ) within children's reach since they could become potential sources of danger. The measurements of the opening made in the top of the modular cabinet and into which the hot plate will be installed are indicated in either fig. 3, comply with the measurements given for the hole into which the appliance will be recessed (see fig. If a wood is installed above the hob, please look at the hood manufacturer instructions regarding the minimum distance between hood and hob (fig. 4). 5) FIXING THE HOT PLATE The hob has a special seal which prevents liquids from infiltrating into the cabinet. Strictly comply with the following instructions in order to correctly apply this seal: - detach the seals from their backing, checking COMPLY WITH THE DIMENSIONS (mm) A 2E 285 B 485 C 57. 5 D E 57. 5 100 min. FIG. 6 6 INSTALLATION 6) ELECTRICAL CONNECTIONS Electrical connection must be carried out in compliance with the specifications and provisions in force. Before proceeding with the connections, check that: - the voltage rating of the appliance and the current sockets suits the maximum power draw of the appliance (see data label affixed to the lower part of the appliance itself). - The system is equipped with an efficient earth connection in compliance with the pertinent provisions in force. [. . . ] Any repairs or adjustments which may be subsequently required may only be carried out by qualified personnel with the utmost care and attention. For this reason, always contact your Dealer or your nearest After Sales Centre whenever repairs or adjustments are required, specifying the type of fault and the model of appliance in your possession. Please also note that genuine spare parts are only available from our After Sales Service Centres and authorized retail outlets. The above data are printed on the data label put on the inferior part of the appliance and on the packing label. [. . . ]