User manual SMEG SF112U

[. . . ] This symbol alerts you to potential hazards that can result in severe personal injury or death. UNDERSTAND SIGNAL WORDS A signal word - DANGER, WARNING or CAUTION - is used with the safety alert symbol. DANGER denotes the most serious hazards. It means you could be killed or seriously injured if you do not immediately follow the instructions. WARNING means you could be killed or seriously injured if the instructions are not followed. [. . . ] Make sure you have everything necessary for correct installation. It is the responsibility of the installer to comply with installation guidelines specified on the model/serial ID plate. The model/serial ID can be found on the internal frame of the oven when the door is opened. • Have your oven installed and properly grounded by a qualified installer, in accordance with these installation instructions. Grounding is mandatory according to the provisions of the electrical system safety regulations. If this appliance is connected to an outside electrical power source, it must be grounded in compliance with local laws, or, if no local laws exist, in compliance with the national ANSI/NFPA 70 code of electrical regulations. • Make sure that the voltage and dimensions of the supply line correspond to the information indicated on the model/serial rating plate. A multi-pole circuit breaker must be available on the supply line with contact gap equal to or greater than 3mm, located in an easily accessible position near the appliance. • Do not attempt to repair or replace any part of your oven unless specifically recommended in this manual. All other service procedures should be performed by a qualified technician. • Disconnect the main power supply. Make sure that the power line rating matches the specifications indicated on the ID plate. The ID Plates are visibly located on the appliance. These ID plates must never be removed. • lf codes permit and a separate ground wire is used, it is recommended that the suitability of the ground path be checked by a qualified electrician. • When a four-wire or three-wire, singlephase, 120/208-volt, 60 Hz or 120/ 240-volt, 60 Hz, AC-only, electrical supply is used, a 20-ampere maximum circuit protection is required. A timedelay fuse or circuit breaker is recommended. 7 EN 1. 2 Electrical requirements FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DEATH, FIRE OR ELECTRICAL SHOCK. Installation • Wire size and connections must conform to the requirements of the National Electrical Code, ANSI/NFPA 70 ELECTRICAL CODE (*) – latest edition or CSA Standard C22. 1-94, Canadian Electrical code, Part 1 (**) and CSA C22. 2 No. O-91 or latest edition and all local codes and ordinances for the kilowatt rating of the appliance. IMPORTANT: Observe all governing codes and ordinances. • Copies of the standards listed above may be obtained from: • (*) National Fire Protection Association, One Batterymarch Park, Quincy, Massachusetts 02169-7471 • (**) CSA International 8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575. To prepare the connection between the oven and the junction box: • Disconnect the power supply to the junction box. • Feed the flexible cable conduit from the oven through the opening of the cabinet. [. . . ] This appliance is manufactured with a green or green-yellow ground wire connected to the oven chassis. 8 Installation EN 9 U. S. Installation only / 3-wire branch circuit See diagram. Where local codes allow the connection of the ground wire from the oven to the power supply cable neutral wire (white wire): • The ground wire must be connected first; • If local codes permit, connect the green or yellow-green ground wire from the appliance and the white wire from the appliance to the power supply neutral wire (white wire). • Connect the red and black leads from the appliance to the to the matching color wires in the junction box using UL/ CSA listed wire connectors. U. S. [. . . ]