User manual SMEG SFP109N

[. . . ] 10 Temperature selection Important . 9 Disposing of the worn out appliance Use . 10 Storing fresh food Placing and installation . 9 Choosing the right place Connection to power supply Adjusting the height of the appliance Maintenance and cleaning . [. . . ] If the appliance has a lock, break it to prevent any accidents (danger of children getting locked inside the appliance).  π The refrigeration system of the appliance is filled with refrigerant and insulating substances which should be treated and processed separately. call your nearest authorized service agent or specialized servicing centre. If you cannot find one, contact your local authorities or your distributor. Be careful not to damage the tubes on the rear wall of the appliance (danger of pollution).  π To avoid pollution of the environment make sure not to damage the hose at the bottom of the appliance. Placing and installation Choosing the right place Place the appliance in a dry and regularly ventilated room. Allowed ambient temperature depends on the model (class) of the appliance and it is stated on the rating plate of the appliance. Never place the appliance near heat emitting devices (e. The appliance should be positioned at least 3 cm away from the electric or gas cooker and at least 30 cm away from the oil or coal stove. If this is not possible, use appropriate insulation. Operation control Appliance operation is controlled with the thermostat knob located in the upper right part inside the appliance. Turn the knob from the STOP (0) position towards 7 and backwards.  π In the STOP (0) position the appliance does not operate (the cooling system is switched off), yet power supply is not cut off (the light is on when you open the refrigerator door).  π Temperature in the refrigerator also depends on how often the door is opened. temperature selection  π Higher settings on the knob (towards 7) mean lower temperatures (colder) in all three compartments of the appliance. Temperature in the interior of the appliance may even drop below 0°C. Higher settings should only be used when higher temperature is recommended or required. π Changes of the ambient temperature affect the temperature in the interior of the appliance (choose the correct setting of the thermostat knob). Ice formed at the rear during the operation of the compressor melts when the compressor is off and water drops slide downwards through the hole in the rear wall into the condensate receptacle placed at the bottom of the appliance. π replace the condenser dish and the bottom rail in the opposite order. Cleaning the appliance Disconnect the power supply before cleaning the appliance. [. . . ]  π Manually defrost the increased ice layer. See Ice formation on the inner rear wall. Ice Formation on the inner rear wall As long as water is drained through the hole in the rear and into the receptacle at the bottom of the appliance, normal automatic defrosting of the appliance is guaranteed. If ice formation on the inner back wall is increased (3-5 mm), ice should be manually defrosted. [. . . ]