User manual SMEG SFP120N

[. . . ] Repairs or modifications carried out by unqualified personnel can cause malfunctions or may damage the appliance, putting your safety in danger. • This appliance is marked according to the European directive 2002/96/EC on “Waste Electrical and Electronic Equipment” (WEEE). This guideline is the frame of a European-wide validity of return and recycling on Waste Electrical and Electronic Equipment, . [. . . ] Keep children away from the device and never let them play with it. Safety Instructions • Please be aware of current local regulations with • • • • • • • • • • • • • • • reference to domestic electrical fittings and gas eduction. Verify that the tension and frequency of the network match those indicated on the label located inside the kitchen hood. If the supply cable is damaged it should be replaced by the manufacturer, the after-sales service or a suitably qualified person in order to avoid hazard. qualified person in order to avoid hazard. In case your cooker hood is not provided with a plug for the mains connection or is not accessible in normal conditions it is necessary to install a disconnection switch to the house installation, according to the local standards for installations. Make sure a good ground connection (this does not apply to class II appliances, indicated accordingly on the rate plate with ) Once the kitchen hood has been installed, ensure that the mains cable to the network is not in contact with sharp metal edges. The fumes should not be extracted through pipes that are used to evacuate the fumes of gas (or another fuel) operated devices. If the extractor fan is going to be used simultaneously with equipment powered by a non-electric energy source, e. g. : gas cookers, then the room must have sufficient ventilation. Excessive fat accumulation in the kitchen hood and metal filters is a fire risk and may also cause dripping, therefore the inside of the kitchen hood and the metal filters must be cleaned at least once a month. The lower part of the kitchen hood must be fitted at least 65cm over gas or mixed hobs. • Do not use vapour cleaners. also be washed in a dishwasher. In this case, it is advisable to stack them vertically to avoid food residues to stick to them. • Cleaning in a dishwasher may damage the metallic surface (blackening it), although this will not affect its fat retention capacity. • Once clean, leave them to dry off and then fit them onto the kitchen hood. • Lamps included in this product are designed exclusively for the illumination of the cooking area. • These lamps are not apt for lighting domestic areas Lamps Cleaning the metal filters • To remove the filters from their fittings, press lightly on the locks and then pull them off. • The metal filters can be cleaned by soaking them in hot water with neutral detergent until the fat dissolves and then rinsing them under the tap or using special anti-grease products. They can Proceed with the following checks before calling the Technical Service: Problem Possible cause The mains cable is not connected to the network. Solution Connect the mains cable to the network. Change or clean the active charcoal and/or metal filters. [. . . ] Change or clean the active charcoal and/or metal filters. Remove the obstruction. Problem solving The kitchen hood does not work. The kitchen hood does not extract sufficiently or vibrates. The lamps do not light up. The lamps are blown The lamps are slack. Change the lamps. [. . . ]