User manual SMEG SFR30

[. . . ] This device stops the fryer from functioning. For the fryer to start functioning again, you must wait until the oil temperature drops; then release the cut-off switch manually to start the appliance again. To carry out this procedure follow the instructions below: · lift up the resistance and secure it in the vertical position; · remove the kettle containing the oil taking care not to burn yourself; · unscrew the tap situated in the rear of the interior casing (fig. If the red button does not release, it means that the temperature sensor of the shut-down thermostat has not cooled down sufficiently. [. . . ] Then shine it with a clean dry cloth, or a chamois cloth for better results. never empty oil into the water-pipe drainage system. Take it to a special collection centre for disposal. After use wait until the oil has cooled down completely, then lift up the resistance, remove the kettle and pour the oil into a suitable container. Do not scrape and scour the appliance to avoid scratching it permanently. Use a soft brush to loosen tough deposits. After cleaning the appliance apply a metal cleaner. For everyday cleaning use a damp cloth or with a some hot water and detergent. Rinse in cold water to remove any remaining detergent and dry the surface. Water spots should be removed with vinegar or lemon, or with a lime removal product. In the case of tough deposits clean with "Sidol for stainless steel" or with "Cerafix". Apply the undiluted cleaner with a paper towel. Let the product take effect, then remove it completely with cold water and dry the parts with a dry cloth. 17 INSTALLATION TECHNICAL DATA FOR INSTALLERS Installation and maintenance listed in this section must only be carried out by qualified personnel (law n° 46 and D. P. R. A faulty installation can cause damage to persons, animals or objects, towards whom the manufacturer cannot be held responsible. The cut-off or automatic control devices of the appliance can only be modified by the manufacturer or by a duly authorized supplier. Packaging (cardboard, bags, expanded polystyrene, nails. . . ) are potentially dangerous. An opening in the top of the piece of modular furniture must be made with the dimensions indicated in fig. 4, making sure that the dimensions of the space required to install the appliance are observed (see fig. 5). 3) INSTALLING THE FRYER Remove outer packaging and inner packing of the various loose parts, then make sure the fryer is not damaged. In case of doubt do not use the appliance and contact a qualified technician. FIG. 5 18 INSTALLATION 4) SECURING THE FRYER To secure the fryer to the worktop the fastening clamps accompanying this booklet must be assembled. The following procedures must be carried out to do this: · remove all movable parts from the fryer; · turn the appliance over taking care to place it on a soft surface to avoid damaging the external surfaces; · remove the clamps "G" from the package and install them as in the diagram in fig. [. . . ] Note: In the event the power cord is replaced, the ground wire must be left longer than the lead wires (fig. 10) and the instructions in the paragraph "ELECTRICAL CONNECTIONS" must be observed. To reassemble the appliance repeat the steps above in the reverse order. 6) PART REPLACEMENT To replace components located inside the fryer the resistance should be lifted up and secured in the vertical position. Take out the oil kettle and loosen the four screws that are under it (see fig. [. . . ]