User manual SMEG SGR10S

[. . . ] The manufacturer shall accept no liability whatsoever for damage caused by tests which are not listed in the Declaration of Conformity. Note Because we are constantly improving our products we reserve the right to update these operating instructions and the functions described in them accordingly. Should you nevertheless notice errors or points that are unclear, please let us know about them. [. . . ] The device must not be operated unattended. Switch the device off or pull out the mains power plug when the device is not in use. Only use power outlets with a grounding conductor and a stable voltage supply. The device must only be set up in dry surroundings. Heavy dust, steam, water drips or water spray compromise the function of the device. Please ensure that the operating voltage corresponds with the data on the device type plate. Please do not lift and transport the device at the sealing edge setting!ΠLeave a gap of 8 inches between the device and the wall. 1 Commissioning Temperature regulator Power connection Power switch Step 1: Step 2: Step 3: Step 4: Plug power cable into power connection. switch device with power switch to setting "1". Control light in the switch illuminates. Set the desired sealing temperature on the temperature regulator as described in chapter 3. As soon as the set sealing temperature is displayed the device is heated up and ready for operation. After the knurled screw has been loosened the lower insertion plate can be set infinitely variably for sealing widths of 0 - 35mm. [. . . ] Month According to load, at least once per year Key: Check Replace Page GB 10 9. 4 Spare parts service Easy spare parts ordering by fax!All you have to do is to copy the order form. [. . . ]