User manual SMEG SI641ID2

[. . . ] INSTRUCTIONS FOR USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ENVIRONMENTAL CARE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 3. 1 OUR ENVIRONMENTAL CARE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Use only cookware with bases suitable for induction hot plates. Suitable containers Unsuitable containers · Copper, stainless steel, aluminium, fireproof · Enamelled steel cookware with thick bases. glass, wood, ceramic and terracotta cookware. · Cast iron cookware with an enamelled base. · Cookware in multilayer stainless steel, ferritic stainless steel and aluminium with a special base. To see whether the pan is suitable, bring a magnet close to the bottom: if it is attracted, the pan is suitable for induction cooking. If you do not have a magnet, you can put a small amount of water in the pan, place it on a cooking zone and start the hot plate. If the symbol appears on the display, it means the pan is not suitable. Use only cookware with a perfectly flat bottom. Using cookware with an irregular bottom could jeopardise the efficiency of the heating system so that cookware is not detected on the hot plate. 4. 4 Limiting the cooking duration The hob has an automatic device which limits the duration of use. If the cooking zone settings are not changed, the maximum duration of operation of each zone depends on the power level selected. When the device for limiting the duration of use is activated, the cooking zone turns off, a short alert is sounded and if the zone is hot the symbol will show on the display. However, the automatic switch-off function takes precedence over the limitation device; the cooking zone only turns off after the time set for automatic switch-off has elapsed. Set power level 1-2 3-4 5-6 7 8 9 Maximum cooking duration in hours 8 6 5 3 2 1½ 4. 5 Protection from hob overheating If the hob is used on full power for a long period, the electronics will have trouble cooling down if the room temperature is high. To avoid excessively high temperatures forming in the electronics, the power to the cooking zone is reduced automatically. If, during normal use of the hob in normal room temperatures, the code E2 appears frequently, this means that cooling is probably insufficient. This may be caused by insufficient cooling slots or the lack of appropriate screening. If necessary, check the installation. 32 Instructions for the user 4. 6 Advice on energy-saving Below you will find advice on how to use your hob effectively and economically. · The diameter of the base of the saucepan must correspond to the diameter of the cooking zone. · When buying a saucepan, check whether the diameter indicated is that of the base or the top of the container, as the top is almost always larger than the base. · When preparing dishes with long cooking times, you can save time and energy by using a pressure cooker, which also makes it possible to preserve the vitamins in the food. · Make sure that the pressure cooker contains enough liquid as, if there is not enough and it overheats, this may cause damage to both the pressure cooker and the cooking zone. · If possible, always cover saucepans with a suitable lid. [. . . ] The minimum distances must also be respected for the edges of the hob on the back as indicated in the mounting illustrations. 8. 2 Section cut from the work surface The following operation requires building and/or carpentry work and must therefore be carried out by a competent tradesman. Installation can be carried out on various materials such as masonry, metal, solid wood or plastic laminated wood as long as they are heat resistant (T 90°C). Create an opening in the counter top with the dimensions shown in the figure, keeping a minimum distance A from the rear edge. This appliance can be mounted against walls higher than the work surface on condition that a minimum distance B be kept between the appliance and the wall as shown in the figure so as to avoid damage from overheating. [. . . ]