User manual SMEG SIM562BSK

[. . . ] ENGLISH SUOMI NORSK SVENSKA DANSK Installation Asennus Montering Installation Installation Page Sivu Side Sidan Side 7 14 21 28 35 Instruction for use Käyttöohje Bruksanvisning Bruksanvisning Brugervejledning Page Sivu Side Sidan Side 7 14 21 28 35 A 52 mm 560 +2 mm 0 R = Min. 50 mm 580 650 700 mm 510 mm 0 490 +2 mm Min. 10 cm 30 483 mm 553 mm +1 0 mm Min. 5 mm 1 2 3 4 IMPORTANT SAFETY INSTRUCTIONS YOUR SAFETY AND THAT OF OTHERS IS VERY IMPORTANT This manual and the appliance itself provide important safety messages, to be read and always observed. [. . . ] In case of problems, contact the dealer or the After-Sales Service. For built-in dimensions and installation instruction, see the pictures in page 4. PREPARING THE CABINET FOR FITTING - Install a separator panel under the hob. WARNING - The lower part of the product must not be accessible after installation. 20 mm - Do not fit the separator panel if an undertop oven is installed. 6-7 cm • The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure. • In order to ensure the correct operation of the product, do not obstruct the minimum required clearance between the hob and the top of the unit (min. • If an undertop oven is installed, make sure the oven is equipped with a cooling system. • Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them. • To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance. Min. 5 mm INSTRUCTIONS FOR USE Control Panel Description Control panel On/Off Multizone Quick access Slider Multizone Control panel lock Cooking zone controls and corresponding display ECO-logic/Timer/Lock function button Switching the hob ON/OFF To switch the hob on, press the button for approx. 2 seconds until the cooking zone displays light up. To switch off, press the same button until the displays switch off. If the hob has been in use, the residual heat indicator “H” remains lit until the cooking zones have cooled down. If within 10 seconds of switching on, no function is selected, the hob switches off automatically. Switching on and adjusting cooking zones Power indicator display Selected cooking zone indication + Decrease power level Slider operation Increase power level Cooking zone positioning 7 After switching the hob on, activate the required cooking zone by pressing the corresponding circular button and place the pot on the zone. With the Slider control it is possible to select the required power level, from min. 9, or booster “P” if available. To increase the power level, slide your finger on the slider from left to right several times; to decrease it, slide in the opposite direction. Alternatively the “+” and “-” quick access buttons can be used. Deactivation of cooking zones To switch off the cooking zone, press the corresponding button for more than 3 seconds. The cooking zone switches off and, if still hot, the letter “H” appears on the zone display. Control panel lock This function locks the controls to prevent accidental activation of the hob. To activate the control panel lock, switch the hob on and press the Timer button for three seconds; an acoustic signal and a luminous indicator near the padlock symbol signal activation. The control panel is locked except for the switching off function. [. . . ] In case of big pot, oval, rectangular and elongated pans make sure to place the pans centered on the cooking zone covering both logos. Examples of good pot placement and bad pot placement : i CLEANING -Do not use steam cleaners. -Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”) is not displayed. IMPORTANT: Do not use abrasive sponges or scouring pads. [. . . ]