User manual SMEG SIM580B

[. . . ] All safety messages will be preceded by the danger symbol and the following words: DANGER WARNING Indicates a hazardous situation which, if not avoided, will result in serious injury. Indicates a hazardous situation which, if not avoided, could cause serious injury. All messages relevant to safety specify the potential risk to which they refer and indicate how to reduce the risk of injury, damage and electric shocks due to incorrect use of the appliance. Make sure to comply with the following: - Use protective gloves to perform all unpacking and installation operations. - The appliance must be disconnected from the power supply before carrying out any installation operation. [. . . ] Only use pots bearing the symbol “INDUCTION SYSTEM” (figure opposite). Place the pot on the required cooking zone before switching the hob on. EXISTING POTS AND PANS OK NO Use a magnet to check if the pot is suitable for the induction hob: pots and pans are unsuitable if not magnetically detectable. - Make sure pots have a smooth bottom, otherwise they could scratch the hob. - Never place hot pots or pans on the surface of the hob’s control panel. This could result in damage. EN5 RECOMMENDED POT BOTTOM WIDTHS Ø 28 cm 17 cm min. XL Ø 28 cm max. M Ø 18 cm 12 cm min. Ø 18 cm max. L Ø 21 cm 15 cm min. Ø 21 cm max. S Ø 14. 5 cm 10 cm min. Ø 14. 5 cm max Max. Min. Ø 12 cm Multizone 23 cm 39 cm INSTALLATION After unpacking the product, check for any damage during transport. In case of problems, contact the dealer or the After-Sales Service. For built-in dimensions and installation instruction, see the pictures in page 2. PREPARING THE CABINET FOR FITTING WARNING - - Install a separator panel under the hob. The lower part of the product must not be accessible after installation. Do not fit the separator panel if an undertop oven is installed. min. 5 mm • • • • • • The distance between the underside of the appliance and the separator panel must respect the dimensions given in the figure. To activate the control panel lock, switch the hob on and press the Timer button for three seconds; an acoustic signal and a luminous indicator near the padlock symbol signal activation. The control panel is locked except for the switching off function. To deactivate the control lock, repeat the activation procedure. The luminous dot goes off and the hob is active again. The presence of water, liquid spilled from pots or any objects resting on the button below the symbol can accidentally activate or deactivate the control panel lock. Timer The timer can be used to set the cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for all the cooking zones. Select the cooking zone to be used with the timer, press the timer and a beep signals the function (see figure). The display shows “00” and the LED indication comes on. The Timer value can be decreased and increased by keeping the slider function “+” and “-” buttons pressed. When the set time has elapsed, an acoustic signal sounds and the cooking zone switches off automatically. To deactivate the timer, keep the Timer button pressed for at least 3 seconds. To set the timer for another zone, repeat the above steps. [. . . ] This message remains active for 60 seconds: in this time you can add or slide pots within the Multizone area as you prefer. After 60 seconds if no pan is placed on the zone, the system stops “searching” pots on that zone, the symbol is disabled. To reactivate the Multizone function, press one of the 2 buttons The Multizone function is also able to detect when a pot is moved from one zone to the other one within the Multizone area keeping the same power level of the zone where the pan originally was placed (see the example in the figure below: if the pot is moved from the front heater to the rear heater, the power level will be shown on the display corresponding to the zone where the pot is placed). It is also possible to operate the Multizone area as two independent cooking zones, using the corresponding button of the single zone. [. . . ]