User manual SMEG SNZ643IS7

[. . . ] Recommendations are given for the correct use of the baskets, spray arms, containers, filters, washing programs, and for operating the controls. Follow the recommended cleaning procedures to ensure that your dishwasher always remains in perfect working order. This manual provides a quick and easy reference for answering all your questions concerning the use of your new dishwasher. INSTALLATION INSTRUCTIONS: these are intended for the qualified technician who must carry out the installation, hook-up and testing of the appliance. USER INSTRUCTIONS: these consist of recommendations for using the appliance, a description of its controls and of the correct cleaning and maintenance procedures. 3 Safety instructions 1. [. . . ] (2) The cycle duration and power consumption may vary according to the water and room temperatures, and the type and amount of dishes. The washing cycle will not take place if the dishwasher door is left open or not properly closed. 11 User instructions TABLE FOR CERTIFICATION BODIES Reference standard Reference program (3 button models) Reference program (2 button models) Load Type of detergent Amount of detergent Rinse aid setting EN 50242 (*) Selector on 4+ ECO 45°C button (*) Selector on 3 12 place-settings B 30 g Depending on the model 3/4 or 4/6 AS/NZS 2007 3. 2 Washing programs Before starting a washing program make sure that: · The water supply tap is open. · The correct amount of detergent has been added to the dispenser. · The baskets have been correctly loaded. · The spray arms are able to rotate freely and without obstruction. · The dishwasher door is securely closed. HALF LOAD WASH SETTING This function is especially suitable for loads up to 6 place settings and allows saving of water and electricity. It is controlled by the HALF LOAD button (3) (see section "3. Description of the controls") and allows washing in the upper basket only. User instructions IMPORTANT: at the end of the program remember to deactivate the function to ensure the next wash is not also carried out in half load mode by mistake. A cutlery basket can be placed in the upper basket, while the lower basket must be left empty. CAUTION: there is no point in loading dishes and cutlery in the lower basket, since the jet of water will only reach the upper basket. CANCELLING THE CURRENT PROGRAM To cancel the program in progress the dishwasher must be switched off by pressing the ON/OFF key (2) (see section "3. Turn the program selector to SOAK and wait for the dishwasher to start. To prevent any water droplets on the upper basket from falling on the dishes in the lower basket, it is advisable to unload the lower basket first, and then the upper basket. 14 User instructions 4. Refill the rinse aid when the optical level indicator becomes clear again, or when the rinse aid warning light illuminates. Replace the cover and turn it in a clockwise direction. Use a cloth to remove any spillage of rinse aid which might lead to the formation of excess foam. · · ADJUSTING THE RINSE AID DISPENSER SETTING The dishwasher is factory set for medium water hardness. However it possible to change the setting by turning the dispenser's selector to the desired position: the amount of rinse aid dispensed is proportional to the selector position. The setting must be increased when the washed dishes appear dull or have circular staining. · · · · · To adjust the rinse aid setting, rotate the dispenser cap through a quarter turn in an anticlockwise direction and remove it. Then use a screwdriver to rotate the rinse aid selector to the desired position. The amount of rinse aid must be increased if the washed dishes appear dull or feature circular stains. If, on the other hand, the dishes are sticky or have white streaks, it is necessary to reduce the rinse aid setting. 18 User instructions ADDING THE DETERGENT To open the detergent dispenser cap, lightly press the button P. Add the detergent and close the cap carefully. During the washing cycle, the dispenser will be opened automatically. · Use only detergents specially formulated for dishwashers. [. . . ] Cleaning and maintenance Before carrying out any work, always disconnect the appliance from the electrical power supply. 5. 1 General warnings and recommendations Avoid the use of acidic or abrasive detergents. Clean the outer surfaces and door-lining of the dishwasher regularly using a soft cloth moistened with water or with a normal detergent suitable for painted surfaces. Clean the door gaskets with a damp sponge. Periodically (once or twice a year) it is advisable to clean the tank and gaskets, using a soft cloth and water to remove any deposits. [. . . ]