User manual SMEG SPR896AOGH

[. . . ] Proper positioning ___________________________________________________ ?Building in __________________________________________________________ ?Hook-up ___________________________________________________________ 2 / USING YOUR APPLIANCE 06 06 07 ?Description of the top _________________________________________________ ? [. . . ] Attach the clips to the hob (depending on the model). On 30, 38, 80 and 90 cm models, ensure that the upper rail across the front of the cabinet does not impede the air flow. If necessary, cut a chamfer. If your hob is located above your oven, the hob?s thermal safety devices can impede the simultaneous use of the hob and the oven?s pyrolysis program. Your hob is equipped with an anti-overheating safety system. This safety device can trigger, for example, when the hob is installed over an oven that is not sufficiently insulated. If this occurs, a series of small lines appears on the control panel. In such circumstances we recommend that you increase the hob?s ventilation by creating an opening in the side of the cabinet, (8 x 5 cm), and/or installing an oven insulation kit available from the after-sales department. ce pa ns tio tila c m ven 4 A 4c m Above a cabinet with a door or drawer Tip 6 1 / INSTALLING YOUR APPLIANCE EN Connection Your appliance should be positioned so that the mains switch is accessible. These hobs must be connected to the mains using a socket in compliance with publication CEI 60083 or an all-pole circuit-breaker device in compliance with the installation rules in force. When power is first supplied to your hob, or after an extended power cut, an indicator light will appear on the control panel. This information will disappear after 30 seconds. ?Hook-up of 220-240V ~ (SIM61B - SIM62B - SPR896AOGH - SIM942B) Green/yellow Blue Brown Connection SIM62BDE ?220-240V Blue Brown ~ Black - grey Green/yellow N L Neutral Phase Earth 32A N L Earth Neutral Phase 32A ?220-240 V monophase hook-up(SIM91B) 32 amp fuses. Brown Blue Green/yellow Green/yellow Bleu Brown Phase ~ Separate the wires before connection Black - grey ?2x230V 2L+2N - 16A L Brown Neutral N Earth Earth Neutral N Phase 20 A Blue Green/yellow 32 A N1 N2 L1 L2 Neutral Phase Earth L ?If the display remains on, your cookware is compatible. If the display flashes, your cookware cannot be used with induction cooking. You can also use a magnet to test the cookware. If a magnet "sticks" to the bottom of the cookware, it is compatible with induction. ?Cookware 12 2 / USING YOUR APPLIANCE EN ?CONTROLS 1 D 2 3 4 A B C E SIM61B-SIM91B-SIM91BDE 1 2 3 4 Front cooking zone Rear cooking zone or full cooking zone 21 cm zone 16 cm zone A Start/stop button B Power level buttons. C Preset power level buttons D Timer buttons. E Full 4600 W cooking zone button 1 D 2 3 4 A B C E SIM62B - SPR896AOGH - SIM942B 1 2 3 4 Front cooking zone Rear cooking zone or full cooking zone Front cooking zone Rear cooking zone or full cooking zone A Start/stop button B Power level buttons. C Preset power level buttons D Timer buttons. When cooking is finished, '0' is displayed and a beep is heard. To clear the display, press any button for the zone in use. The display is otherwise automatically cleared in a few moments. ? [. . . ] MAINTAINING YOUR APPLIANCE TYPE OF STAINS/SPOTS USE Light. WHAT TO DO Thoroughly moisten the zone to be cleaned with hot water, then wipe off. Thoroughly moisten the zone to be cleaned with hot water. Use a scraper for glass to remove the large bits, follow with the rough side of a disinfectant sponge, and then wipe off. [. . . ]