User manual SMEG STL120

[. . . ] "Water Stop" Indication - can be released by excess foaming or a leak in the washing machine B. "Water Tap" Indication - check your washing machine's water supply C. "Programme Sequence" Indicator E. "Spin Speed Reduction" Button F. [. . . ] The display shows the approximate duration of the chosen programme (in hours and minutes) and the pilot lamp of the "Start/Pause" button flashes. The readout of temperature and predefined spin speed corresponding to the selected programme is displayed. The preselected temperature can be altered by pressing the "+" or "-" button (depending on model). Select an option When you select an option, the corresponding indicator lamp lights up, unless the combination of the programme, the additional options and the temperature is not possible. Select the programme Start Delay (depending on model) The "Start Delay" allows the machine to be run at the user's convenience, for example at night when electricity is cheaper. · Select programme, temperature and options. · Press the "Start Delay" button to select the delay time of 1 to 19 hours; · Press the "Start/Pause" button. The pilot lamp of the "Start/Pause" button lights up and the lamp of the "Start Delay" button flashes. · The time delay indication disappears when the programme starts and is replaced by the remaining time. · The number of hours preselected can be reduced later by pressing the "Start Delay" button again. To cancel the "Start Delay". Programme start · Turn the programme selector to the " " position. · Reselect the desired programme and options and press the "Start/Pause" button. Turn on the tap and press the "Start/Pause" button. The pilot lamp of the "Start/Pause" button lights up. After starting the programme, the sequence indication signals the Wash, Rinse and Spin phases. Note: If there is a power interruption or if the appliance is connected during the cycle, the programme will start again at the point where it was interrupted. Door lock For reasons of safety, the door is locked during certain phases of the cycle. At the end of the cycle or during an interruption, the door unlocks automatically after about 1 minute. Programme end · The remaining time indicator shows "0:00" and the "End" lamp lights up, or "End" is indicated on the display (depending on model). Turn the programme selector to the " " position. Open the door and drum flaps and unload the machine. Change the programme or options during the cycle 1. Select the new programme with the programme selector. If necessary, select the additional options and the spin speed. The indicator lamp of the "Start/Pause" button flashes. Note: the "Start Delay" and "Prewash" options cannot be selected after a change of programme. [. . . ] This operation must be carried out exclusively by a qualified technician. Connect the water drain hose 1. Unhook the drain hose from the left and right hose connections, see arrow A in figure. Important: Do NOT loosen the drain hose connection from the right side, see arrow B in figure. Otherwise, there is the risk of leakage and of scalding with hot water. [. . . ]