User manual SMEG STL80

[. . . ] "Spin Speed Reduction" Button : option / Yes: dosing required 1) A C B Max. Detergents and additives load Prewash Main Softener Bleach Wash kg 2) Do not use liquid detergents. For improved garment care, spin speed is zero in this programme. Special Options Temperature Intensive Half Spin Speed Rinse Load Reduction °C Max. [. . . ] When using concentrated fabric softeners, add water in the detergents dispenser up to "MAX" level mark. To prevent dispensing problems when using highly concentrated powder and liquid detergents, use the special detergent ball or bag supplied with the detergent and place it inside the drum. FRENCH °fH 0-12 12-25 25-37 over 37 ENGLISH °eH 0-9 9-17 17-26 over 26 WATER HARDNESS CHART WATER HARDNESS CATEGORY 1 2 3 4 CHARACTERISTICS soft medium hard very hard GERMAN °dH 0-7 7-14 14-21 over 21 Filling up with detergents and additives The dispenser will have three or four compartments depending on model. Pour in the detergent: · Washing powder for prewash and main wash · Washing powder for main wash without prewash · Fabric softeners and starch products, no more than to "MAX" mark. · Chlorine bleach, no more than to "MAX" mark. (only four compartments model) · Stain removers · Water softeners (water hardness class 4) · Starch (dissolved in water) Be careful not to fill more than the "MAX" level mark. Do not use liquid detergents for programmes with prewash. For programmes without prewash and temperatures from cold to 40° C, it is recommended to use liquid detergents to avoid whitish residues on the laundry. GB 6 PROGRAMME SELECTION Preparation of wash cycle 1. Load the machine, close the drum flaps and check that they are properly locked. Add detergents and additives into the dispenser to no more than the "MAX" level mark. Please refer to "Detergents and additives". Turn the programme selector knob to the desired programme. Turn the temperature selector knob (if available) to the desired temperature. Turn the spin speed selector knob (if available) to the desired spin speed. If the spin speed "0" is selected, the final spin is cancelled, but not intermediate spins. Select the desired options as described in the Programme Chart. Programme start Switch on the washing machine- the indicator lights up. Note: If there is a power interruption or if the washing machine is disconnected during the cycle, the programme will run again from the point where it was interrupted. End of wash cycle · The programme selector knob is in the Stop position. Wait for the lid to unlock (about 1 minute). Open the lid and the drum flaps and unload the machine. Change the programme during the wash cycle 1. Start the programme by switching on the machine. Pause/Interrupt a programme If for any reason you wish to interrupt the programme for a certain time and continue it later: 1. After the desired pause turn on the machine again. Cancel programme 1. [. . . ] This operation must be carried out exclusively by a qualified technician. Connect the water drain hose 1. Unhook the drain hose from the left and right hose connections, see arrow A in figure. Important: Do NOT loosen the drain hose connection from the right side, see arrow B in figure. Otherwise, there is the risk of leakage and of scalding with hot water. [. . . ]