User manual SMEG SUK90MFX

[. . . ] 9. INSTRUCTIONS FOR SAFE AND PROPER USE _______________________________4 INSTALLATION OF THE APPLIANCE_________________________________________6 ADAPTATION TO DIFFERENT TYPES OF GAS ________________________________8 FINAL OPERATIONS_____________________________________________________11 DESCRIPTION OF CONTROLS ____________________________________________13 USE OF THE HOB _______________________________________________________15 USE OF THE OVEN______________________________________________________17 ELECTRONIC PROGRAMMER_____________________________________________19 AVAILABLE ACCESSORIES _______________________________________________21 10. CLEANING AND MAINTENANCE ___________________________________________22 11. EXTRAORDINARY MAINTENANCE _________________________________________24 THESE INSTRUCTIONS ARE VALID ONLY FOR THE END USER COUNTRIES WHOSE IDENTIFICATION SYMBOLS APPEAR ON THE COVER OF THIS MANUAL. INSTRUCTIONS FOR THE INSTALLER: these are for the qualified technician who must carry out a suitable check of the gas system, install the appliance, set it functioning and carry out an inspection test. INSTRUCTIONS FOR THE USER: these contain user advice, description of the commands and the correct procedures for cleaning and maintenance of the appliance. 3 Introduction 1. [. . . ] Position the skirt above the top, taking care to align pins C with holes D. Secure the skirt to the top by tightening screws A 11 Instructions for the installer 4. 4 Wall fixing · · · · Stretch out the chain attached to the cooker horizontally so that the other end touches the wall. Mark the wall in the position where the hole is to be drilled. Drill the hole, insert a wall plug and attach the chain. Move the cooker up against the wall. 12 Instructions for the user 5. DESCRIPTION OF CONTROLS 5. 1 Front control panel All the cooker controls and commands are on the front panel. If the cooker is equipped with an electronic programmer, before using the oven make sure that the symbol ; appears on the display. Hold the knob down for a few seconds to allow the thermocouples to heat up. The burner may go out when the knob is released: this is because the thermocouple has not been sufficiently heated. Repeat the operation holding down the knob a little longer. This operation is not necessary for burners without thermocouples. For models with thermocouples, should the burner accidentally go out, a safety device will be activated which stops the gas flow even if the tap is open. 6. 2 Practical advice for using the hob burners For better use of the burners and lower gas consumption, use covered vessel that are proportional in size to the burner to prevent the flame from licking the sides (see paragraph "6. 3 Diameter of "). When water reaches the boiling point, lower the flame so that it doesn't overflow. To avoid burns or damage to the hob, all vessels or griddle plates must be placed within the perimeter of the hob. All vessels must have a flat and smooth bottom. When using fats or oils, be extremely careful that they don't overheat and catch fire. If the flame accidentally goes out, turn off the control knob and wait at least 1 minute before trying to re-light the burner. 15 Instructions for the user 6. 3 Diameter of the vessels to be used on each burner BURNERS Ø min. (in cm) 12-14 16-24 18-26 18-26 1 2 3 4 Auxiliary Semi rapid Rapid Triple crown 16 Instructions for the user 7. USE OF THE OVEN For the models with electronic programmer, before using the oven make sure that the display shows the symbol . 7. 1 Warnings and general advice Using the oven and the grill for the first time, heat them to the maximum temperature (260°C) for as long as it takes to burn off any production oil residues which could give a nasty flavour to the food. To adjust refer to After a power cut, the oven display will flash intermittently and show paragraph "8. During cooking, do not cover the bottom of the oven with aluminium or tin foil and do not place pans or oven trays on it as this may damage the enamel coating. If you wish to use greaseproof paper, place it so that it will not interfere with the hot air circulation inside the oven. To prevent problems caused by steam in the oven, open the door in two stages: half open (5 cm approx. ) for 4-5 seconds and then fully open. [. . . ] Continuous contact of the grids with the flame can cause the enamel near the hot areas to be altered. This is completely natural and does not compromise the functionality of the component. 10. 2. 2 Burner caps and flame cap crowns The caps and flame-spreader crowns are extractable to facilitate cleaning. Wash them in hot water with non-abrasive detergent, taking care to remove any encrustations, and wait until they are perfectly dry. WARNING: do not wash these components in the dishwasher. [. . . ]