User manual SMEG WD3060-R

[. . . ] INSTALLATION AND CONNECTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 5. 1 Overall dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 5. 2 Positioning and levelling the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 5. 3 Preparing the Home Garden . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Completely unscrew the feet and fit the studs into the holes on the pedestal. Now secure the pedestal to the Home Garden using the 4 provided nuts"A". 4) ALWAYS PLACE THE HOME GARDEN IN A DRY, WELL VENTILATED LOCATION. NEVER EXPOSE IT TO DIRECT SUNLIGHT OR INSTALL IT OUTDOORS. DO NOT INSTALL IT CLOSE TO SOURCES OF HEAT OR DIRECTLY IN THE AIR FLOW FROM A/C EQUIPMENT. 9 Installation and connection 5. 3 Preparing the Home Garden After you have installed your Home Garden according to the instructions in Section "5. 2 Positioning and levelling the appliance", it has to be opened in order to position some parts inside. Access to the inside of the Home Garden is possible from both side panels. GETTING TO KNOW YOUR APPLIANCE HUMIDIFIER WATER TANK CONTROL PANEL SLIDING TRAYS PLANT POTS VAPOUR DELIVERY TUBE LED LAMP HUMIDITY AND INTERNAL TEMPERATURE SENSOR TANK FILLER CAP HEATING PLATES (FIG. 8) EXTERNAL LIGHT SENSOR INTERNAL CLOCK SETTING/DISPLAY SYMBOL HUMIDITY SUPPLY/EMPTY TANK SYMBOL INTERNAL TEMPERATURE/TIME DISPLAY STANDBY SYMBOL INTERNAL AIR HUMIDITY PERCENTAGE/MINUTES DISPLAY REMOTE CONTROL LOCK SYMBOL LED LAMP MAXIMUM LIGHT SYMBOL CUTTINGS FUNCTION SYMBOL REMOTE CONTROL INFRARED SENSOR 8. 1 External light sensor This sensor detects the environmental light level also controlling the lamp on or off during lighting period set with the program. 8. 2 Internal clock setting/display symbol This symbol indicates that the key on the remote control has been pressed to show the current time on the displays. For instructions for setting the time, see "9. 6 Clock display/setting key" 8. 3 Humidity supply/empty tank symbol This symbol lights up whenever the key on the remote control is pressed. It flashes when the water tank level goes into reserve and the humidifier is no longer able to deliver the required vapour. For filling the water tank, read paragraph "11. 1 Filling the tank". Once this check has terminated, the system will ask you to select one of the 3 pre-set programs or the manual setting program . For selection of the right program and how to activate it, refer to "10. 3 Selecting the programme". Once the program has been selected, the appliance will prompt you to set the time. For instructions for setting the time, see "9. 6 Clock display/setting key". The key is also used for unlocking the Home Garden's settings: Ten minutes after any button has been pressed for the last time, the Home Garden enters the "lock" mode and a dot lights up on the humidity display (see point page 14). This is a precaution against misuse, accidental or in play, by children, who may attempt to change the settings and thus affect the growth of the plants. To unlock the settings, point the remote control at the Home Garden and hold this key down for a few seconds until the point on the display disappears. It is now possible to use the other keys on the remote control again. 16 Remote control WARNING: WHEN IN STANDBY, THE HOME GARDEN NO LONGER AUTOMATICALLY CONTROLS ITS INTERNAL CLIMATE. IN CASE OF A POWER BLACKOUT, THE ELECTRONIC CIRCUIT BOARD WILL RETAIN THE LAST PROGRAM SET BY THE USER IN THE MEMORY, AND WILL REPEAT IT AUTOMATICALLY WHEN THE POWER SUPPLY IS RESTORED. . 9. 3 Cuttings function on key This key activates the "Cuttings" function, which automatically operates the Home Garden's heating elements. This is intended for growing cuttings or immediately after planting seeds. The pots intended for this function are those around the edge of the lowest level. [. . . ] To prevent overheating of the ultrasound nebuliser, the Home Garden operates it in on/off mode. Therefore, whether or not the preset humidity level is reached depends on the humidity of the Home Garden's external environment and the nebuliser cycle selected. 20 Maintenance and cleaning 11. MAINTENANCE AND CLEANING DISCONNECT THE ELECTRICAL POWER SUPPLY BEFORE ANY PROCEDURE THAT REQUIRES ACCESS TO LIVE PARTS. The Home Garden requires very simple periodic maintenance and cleaning; if done regularly, it will be keep in excellent operating and aesthetic condition. 11. 1 Filling the tank The Home Garden's tank is empty when purchased. It must be filled in order for the appliance to operate. It is best to fill the tank only after having positioned the Home Garden. [. . . ]