User manual SMEG WD5090-R

[. . . ] WARNING means you can be killed or seriously injured if you do not follow the instructions. CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. All safety messages will inform you of potential hazards, on how to reduce the risk of injury and what can occur if the instructions are not followed. IMPORTANT: Installation and grounding must comply with applicable codes. [. . . ] Have a qualified technician install and ground this appliance, in accordance with these installation instructions. It is the responsibility of the installer to comply with the installation clearances specified on the model/serial I. D. plate is located under the cooktop base. ELECTRICAL GROUNDING REQUIRED: See the "4. It is the customer's responsibility: 1 To contact a qualified electrician to install the appliance 2 To ensure that the electrical system is adequate and in conformance with the national ANSI/ NFPA 70 ELECTRICAL CODE ­ LATEST EDITION, or the CANADIAN ELECTRICAL CODE, C22. 11 ­ 1982 and CAN/CSA C22. 2 No. 61 (or latest edition), and all local codes and ordinances. Before you plug in the electrical cord, make sure that all the controls are in the OFF position. Never modify or alter the construction of the appliance. - - - CAUTION: This unit is designed as a cooking appliance. Based on safety considerations, never use it for warming or heating a room. Immediately after installation inspect the appliance, following the instructions in this booklet. If the appliance doesn't work properly, disconnect it from the electrical power supply and call the technical assistance center. Make sure that the voltage and capacity of the power line conforms to the data shown on the I. D. Do not remove this plate for any reason. If codes permit and a separate ground wire is used, it is reccomended that a qualified electrician determine that the ground path is adequate. When a four-wire or three-wire, single-phase, 120/240-volt, 60 Hz, AC-only, electrical supply is available, a 50 ampere maximum circuit protection is required (or, if specified on the model/serial I. D. plate, when a four-wire or three-wire, single-phase 120/208-volt, 60 Hz, AC-only electrical supply is available, a 40ampere maximum circuit protection is required), fused on both sides of the line. A time-delay fuse or circuit breaker is recommended. Wire size and connections must conform to the requirements of the National Electrical Code, ANS/NFPA 70 ­ Latest edition (*) or CAN/CSA Standard C22. 1, Canadian Electrical code, Part 1 ­ Latest edition (**) and all local codes and ordinances for the kilowatt rating of the range. Copies of the standards listed may be obtained from: (*) National Fire Protection Association Batterymarch Park ­ Quincy, Massachusetts 02269; (**) CSA International 8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575 . This appliance is manufactured with a yellow-green ground wire connected to the appliance frame. After making sure that the power has been turned off, connect the flexible conduit from the appliance to the junction box using a U. L. Picture 1 and Picture 2 and the instructions provided below are the most common way of connecting the appliance. [. . . ] Complete electrical connections according to local codes and ordinances. This cooktop must be connected to a grounded, metallic, permanent wiring system, or a ground connector should be connected to the ground terminal or wire lead on the cooktop. Connection at connection block must be copper wire only. 10 Instructions for the Installer NOTE: Use this method only if local codes allow connecting the cabinet ground conductor to the neutral wire of the power supply cord WARNING ELECTRIC SHOCK HAZARD Turn power supply off before connecting wires. Failure to follow these instructions can results in death, fire, or electrical shock. [. . . ]