User manual SMEG WM40T-1

[. . . ] THE CONTENTS SECTION 1:BEFORE USING · · · · · · · Safety warnings Recommendations Removal of transportation screws Adjustment of feet Electrical connection Water supply connection Water drain connection SECTION 2:INSTALLATION SECTION 3:TECHNICAL SPECIFICATIONS SECTION 4:CONTROL PANEL · · · · · · · · · · · · · · Start/Pause button Function indicator lights Function buttons Spin speed selector Program knob Before washing Running the machine Water inlet filters Pump filter Detergent drawer Siphon plug The cabinet The drum Remove of your machine from lime SECTION 5:WASHING YOUR LAUNDRY SECTION 6:MAINTENANCE AND CLEANING SECTION 7: PRACTICAL INFORMATION SECTION 8:AVOIDING MINOR FAULTS SECTION 9:AUTOMATIC FAILURE DETECTION SYSTEM SECTION 10:INTERNATIONAL WASHING SIGNS 28 SECTION 1:BEFORE USING SAFETY WARNINGS · · · · · · · · · · · · · · · · Do not use a multiple socket or extension cord. Do not insert a plug with damaged or broken cord into the socket. If the cord is damaged it should be replaced by the manufacturer or appointed service agent in order to avoid a hazard. Never remove the plug from the socket by pulling from the cord section. [. . . ] To clean the sediment, pull out the detergent drawer from time to time. To pull out the detergentdrawer: · Pull the detergent drawer to the end. (DIAGRAM-1) · Lift the front of the drawer, continue to pull until the drawer is pull out. (DIAGRAM-2) · Wash will an old toothbrush and excessiveamount of water. · Take off the leftover detergent avoid to drop into your machine. · After drying the detergentdrawer put into the housing in the same manner you pull out. DIAGRAM-1 DIAGRAM-2 44 SIPHON PLUG Pull out the detrgent drawer. Remove the siphon plug and clean the residues of the softener thoroughly. Fit the cleaned siphon plug in its location. Check if it placed properly. THE CABINET Clean the exterior surface of the cabinet of your machine with lukewarm water and a cleaning substance that will not irritate the cabinet. After rinsing with clean water, wipe it with a soft and dry cloth. WARNING! If the machine is installed in a location where the ambient temperature can fall below 0 °C, do the following when it will not be in use: · Plug in the machine. · Close the water tap and pull out the water inlet hose or hoses from the tap. · Place the ends of the water drain and water inlet hoses in a cup on the ground. · Adjust the program knob to "Draining" program. · The program ready light will be on. · Run the program by pressing the start/pause button. · Unplug your machine when the program is over (program end light is on). When you complete these proces, the remaining water inside the machine will be drained and thus formation of ice in the machine will be prevented. When you operate your machine again, be sure that the ambient temperature is above 0 °C. THE DRUM Do not leave metal parts like needles, staples or coins inside your machine. These pieces cause formation of rust stains in the drum. To eliminate these stains of rust, use a cleaning substance without chlorium and follow the warnings of the cleaning substance producer. For cleaning of the rust stains, never use dish-washing wires or similar rough objects. REMOVE OF LIME FROM YOUR MACHINE If you arrange the amount of the detergent you use in your machine properly, there will be no need for lime removal. However, if you desire to apply the removal procedure, use the lime protectors in the market and pay attention to their warnings. WARNING! The lime eliminating substances contain acids and this may cause colour modifications in your clothes along with an adverse effect on your machine. 45 SECTION 7:PRACTICAL INFORMATION Alcoholic beverages: The stain point, should first be washed with cold water, than should be wiped with glycerine and water and be rinsed with water mixed with vinegar. Shoe Polish: The stain should be slightly scratched without ruining the cloth, rubbed with detergent and rinsed. [. . . ] The end of the water drain hose is in a position too low according to the machine. The water is at the lower part of the drum. The pieces of some detergents which do not dissolve in water may stick to your clothes as white stains. METHODS OF ELIMINATION Put the clothes in your machine in a manner not to exceed its maximum capacity. Use the amount of detergent according to the declaration of the detergent producer. [. . . ]